messages from 2026-10-15 03:59:03 to 2026-10-15 21:20:57 UTC [more...]
[PATCH] spi: imx: fix slab corruption from undersized DMA bounce buffers
2026-10-15 21:20 UTC (2+ messages)
[PATCH] spi: bcm-qspi: reject oversized dummy bytes in mspi exec_mem_op
2026-10-15 18:17 UTC (2+ messages)
[PATCH v10 00/19] spi: cadence-quadspi: add PHY tuning support
2026-10-15 17:47 UTC (2+ messages)
[PATCH] spi: npcm-fiu: limit UMA data_size to the 16-byte staging buffer
2026-10-15 14:09 UTC (2+ messages)
[PATCH] spi: jcore: fix divide-by-zero when speed_hz is zero
2026-10-15 11:26 UTC (2+ messages)
[PATCH v3] spi: omap2-mcspi: handle DMA setup failures
2026-10-15 13:02 UTC (2+ messages)
[PATCH 0/2] spi: cadence-xspi: two memory-safety fixes in the slave-DMA paths
2026-10-14 15:45 UTC (2+ messages)
[PATCH v2 19/24] dt-bindings: spi: Add ZTE ZX family SPI flash controller binding
2026-10-15 14:29 UTC (6+ messages)
` [PATCH v2 20/24] spi: zx: Add ZTE ZX family SPI flash controller driver
[PATCH] spi: tegra114: assert CS GPIO for every transfer in a message
2026-10-15 14:05 UTC (2+ messages)
Patchwork housekeeping for: spi-devel-general
2026-10-15 13:58 UTC
[RFC PATCH 0/4] spi: cadence-xspi: add ACMD PIO support for NAND and NOR
2026-10-15 13:03 UTC (8+ messages)
[PATCH v3 0/8] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-10-15 12:58 UTC (9+ messages)
` [PATCH v3 1/8] soc: qcom: geni-se: Populate clk_perf_tbl with SE source clock frequencies from perf OPP table
` [PATCH v3 2/8] soc: qcom: geni-se: Add helper to set SE clock rate via OPP
` [PATCH v3 3/8] soc: qcom: geni-se: Remove OPP rate reset from resource deactivation
` [PATCH v3 4/8] serial: qcom-geni: Use geni_se_set_rate() for source clock configuration
` [PATCH v3 5/8] spi: qcom-geni: Use geni_se_set_rate() for setting source clock frequency
` [PATCH v3 6/8] i2c: qcom-geni: Vote for SE clock rate using OPP
` [PATCH v3 7/8] i2c: qcom-geni: Use common GENI resource initialization helper
` [PATCH v3 8/8] i2c: qcom-geni: Use geni_se_set_rate() for setting source clock frequency
[PATCH] spi: sprd-adi: reject transfers shorter than 4 bytes
2026-10-15 12:33 UTC (5+ messages)
` [PATCH v2 0/2] mfd/spi: sprd: fix ADI transfer length handling
` [PATCH v2 1/2] mfd: sprd-sc27xx: pass byte length to spi_read()
` [PATCH v2 2/2] spi: sprd-adi: enforce the exact transfer length
[PATCH 0/2] spi: use devm_platform_ioremap_resource() in sh-hspi and jcore
2026-10-13 19:50 UTC (2+ messages)
[PATCH 0/5] spi: replace strcpy(), sprintf() and simple_strtoul() with strscpy(), snprintf() and kstrtoul()
2026-10-13 19:51 UTC (2+ messages)
[PATCH] spi: meson-spicc: fix invalid DMA unmap on mapping failure
2026-10-13 20:40 UTC (2+ messages)
[PATCH v3 0/7] spi: Add support for panic mem writes
2026-10-15 12:10 UTC (5+ messages)
` [PATCH v3 2/7] mtd: spi-nor: Wait for NOR ready with poll_timeout_us()
` [PATCH v3 6/7] spi: cadence-xspi: Add support for panic writes
[PATCH] spi: tegra20-slink: bound copies to t->len
2026-10-15 11:28 UTC (2+ messages)
[PATCH v2] spi: ljca: validate the response length before copying the data
2026-10-13 19:46 UTC (2+ messages)
[PATCH v2] spi: cadence-qspi: Prevent SPI NAND continuous reads
2026-10-13 19:34 UTC (2+ messages)
Patchwork housekeeping for: spi-devel-general
2026-10-15 6:58 UTC
[PATCH v2] spi: omap2-mcspi: handle DMA setup failures
2026-10-15 6:44 UTC (3+ messages)
[PATCH v2 0/9] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-10-15 5:13 UTC (5+ messages)
` [PATCH v2 5/9] serial: qcom-geni: Use geni_se_set_rate() for source clock configuration
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).