Re: [PATCH] staging: media: atomisp: pci: Format multi-line comments according to coding-style in file atomisp_cmd.c

[Sakari Ailus <sakari.ailus@linux.intel.com>]

Hi Aline,

Thanks for the patch.

On Wed, Apr 14, 2021 at 03:27:55PM -0300, Aline Santana Cordeiro wrote:
> Format multi-line comments according to the coding-style.
> Issue detected by checkpatch.pl.
> 
> Signed-off-by: Aline Santana Cordeiro <alinesantanacordeiro@gmail.com>
> ---
>  drivers/staging/media/atomisp/pci/atomisp_cmd.c | 109 ++++++++++++++----------
>  1 file changed, 65 insertions(+), 44 deletions(-)
> 
> diff --git a/drivers/staging/media/atomisp/pci/atomisp_cmd.c b/drivers/staging/media/atomisp/pci/atomisp_cmd.c
> index 592ea99..6113785 100644
> --- a/drivers/staging/media/atomisp/pci/atomisp_cmd.c
> +++ b/drivers/staging/media/atomisp/pci/atomisp_cmd.c
> @@ -67,7 +67,8 @@
>   * At 15fps this means 133ms. We set the timeout a bit longer.
>   * Each flash driver is supposed to set its own timeout, but
>   * just in case someone else changed the timeout, we set it
> - * here to make sure we don't damage the flash hardware. */
> + * here to make sure we don't damage the flash hardware.
> + */
>  #define FLASH_TIMEOUT 800 /* ms */
>  
>  union host {
> @@ -562,7 +563,8 @@ irqreturn_t atomisp_isr(int irq, void *dev)
>  			 * and driver needs to keep old sequence_temp value.
>  			 * NOTE: There is assumption here that ISP will not
>  			 * start processing next frame from sensor before old
> -			 * one is completely done. */
> +			 * one is completely done.
> +			 */
>  			if (atomic_read(&asd->sequence) == atomic_read(
>  				&asd->sequence_temp))
>  				atomic_set(&asd->sequence_temp,
> @@ -1247,7 +1249,8 @@ void atomisp_buf_done(struct atomisp_sub_device *asd, int error,
>  
>  	if (IS_ISP2401) {
>  		/* If there are no buffers queued then

This should begin with:

		/*
		 *

And the same for the rest. Apart from this the patch seems fine.

-- 
Kind regards,

Sakari Ailus