[PATCH] spi: tegra114: initialize native chip selects inactive

[Abraham Zukor <abe@maticrobots.com>]

tegra_spi_probe() initializes SPI_COMMAND1 with only SPI_M_S, leaving
CS_POL_INACTIVE clear for every chip select. This drives every native
active-low chip select low until tegra_spi_setup() runs for that device.

SPI children are registered and probed one at a time. A synchronous
probe of an earlier child can therefore transfer while a later child's
chip select is still asserted. On a Tegra234 system with active-low devices
on CS0 and CS1, this caused both devices to be selected when the CS1
device probed first. Its initialization then intermittently failed. A
logic analyzer showed CS0 remained low throughout the CS1 transfer and
went high only after the CS1 probe failed.

The Tegra234 TRM also documents all CS_POL_INACTIVE bits as one after
reset, so the existing probe code replaces the hardware's safe reset
polarity with zeros on that SoC.

Set CS_POL_INACTIVE for all native chip selects during controller probe.
This matches SPI's default active-low polarity and the documented
Tegra234 reset polarity. tegra_spi_setup() continues to configure the
inactive polarity of SPI_CS_HIGH devices before their drivers probe.

Fixes: f333a331adfa ("spi/tegra114: add spi driver")
Assisted-by: Codex:GPT-5
Signed-off-by: Abraham Zukor <abe@maticrobots.com>
---
 drivers/spi/spi-tegra114.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/spi/spi-tegra114.c b/drivers/spi/spi-tegra114.c
index aa44ffd09e61..c28aae093d57 100644
--- a/drivers/spi/spi-tegra114.c
+++ b/drivers/spi/spi-tegra114.c
@@ -1394,7 +1394,7 @@ static int tegra_spi_probe(struct platform_device *pdev)
 	reset_control_assert(tspi->rst);
 	udelay(2);
 	reset_control_deassert(tspi->rst);
-	tspi->def_command1_reg  = SPI_M_S;
+	tspi->def_command1_reg  = SPI_M_S | SPI_CS_POL_INACTIVE_MASK;
 	tegra_spi_writel(tspi, tspi->def_command1_reg, SPI_COMMAND1);
 	tspi->spi_cs_timing1 = tegra_spi_readl(tspi, SPI_CS_TIMING1);
 	tspi->spi_cs_timing2 = tegra_spi_readl(tspi, SPI_CS_TIMING2);
-- 
2.54.0