Re: [PATCH 1/2] ARM: tegra: enable I2C Mux driver for PCA9546 in defconfig

[Stephen Warren <swarren-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org>]

On 02/12/2014 01:09 PM, Bryan Wu wrote:
> On Wed, Feb 12, 2014 at 11:08 AM, Stephen Warren <swarren-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org> wrote:
>> On 02/07/2014 04:54 PM, Bryan Wu wrote:
>>> PCA9546 is used in Cardhu Tegra30 board to connect to 3 cameras.
>>> Enabling this driver for Tegra V4L2 soc camera driver and camera
>>> sensor drivers.
>>
>> I've squashed patch 1/2 into Tegra's for-3.15/defconfig branch, and
>> applied patch 2/2 to Tegra's for-3.15/dt branch.
>>
>> Note that your patches were sent with an email "From" address that
>> didn't match your signed-off-by tag, yet "git send-email" didn't insert
>> a "From" header in the email body. Can you please check your git user ID
>> and/or email settings. Consequently, I had to adjust the git author
>> field in git to match your s-o-b line.
> 
> My bad. I need to update my git send-email script to use --from "Bryan
> Wu <pengw-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>" instead of --from "Bryan Wu
> <cooloney-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>"
> 
> Need I resubmit this patchset?

No need to resent; I fixed them up.

Why not just put the correct values in ~/.gitconfig?

Perhaps this is because you switch between NVIDIA and non-NVIDIA email
addresses and/or mail servers, so you can't make ~/.gitconfig static and
universally correct? If you have a recent enough git, what I do is:

$ cat ~/.gitconfig
[include]
        path = .gitconfig-user
        path = .gitconfig-email-server
...

$ cat ~/.gitconfig-user-nvidia
[user]
	name = Stephen Warren
	email = swarren-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org

$ cat ~/.gitconfig-user-wwwdotorg
[user]
	name = Stephen Warren
	email = swarren-3lzwWm7+Weoh9ZMKESR00Q@public.gmane.org

~/.gitconfig-user is a symlink to one of ~/.gitconfig-user-*, and I have
a script that deletes the link and points it at a new location:

$ cat `which git-switch-user`
#!/bin/bash

cd $HOME
mainfile=.gitconfig-user
newlink=${mainfile}-$1
if [ ! -f ${newlink} ]; then
    echo ERROR: ${newlink} not found
    exit 1
fi

rm -f ${mainfile}
ln -s ${newlink} ${mainfile}

... and the same thing for email servers.

Then, I can run e.g.:

git-switch-email-server nvidia; \
git send-email --to internal-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org *.patch; \
git-switch-email-server severn-port-forwarded