messages from 2019-07-16 04:37:09 to 2019-07-21 21:04:45 UTC [more...]
[PATCH V6 00/21] SC7 entry and exit support for Tegra210
2019-07-21 21:04 UTC (24+ messages)
` [PATCH V6 01/21] irqchip: tegra: Do not disable COP IRQ during suspend
` [PATCH V6 02/21] pinctrl: tegra: Add suspend and resume support
` [PATCH V6 03/21] pinctrl: tegra210: Add Tegra210 pinctrl pm ops
` [PATCH V6 04/21] clk: tegra: Save and restore divider rate
` [PATCH V6 05/21] clk: tegra: pllout: Save and restore pllout context
` [PATCH V6 06/21] clk: tegra: pll: Save and restore pll context
` [PATCH V6 07/21] clk: tegra: Support for OSC context save and restore
` [PATCH V6 08/21] clk: tegra: clk-periph: Add save and restore support
` [PATCH V6 09/21] clk: tegra: clk-super: Fix to enable PLLP branches to CPU
` [PATCH V6 10/21] clk: tegra: clk-super: Add save and restore support
` [PATCH V6 11/21] clk: tegra: clk-dfll: Add suspend and resume support
` [PATCH V6 12/21] cpufreq: tegra124: "
` [PATCH V6 13/21] clk: tegra210: Use fence_udelay during PLLU init
` [PATCH V6 14/21] clk: tegra210: Add suspend and resume support
` [PATCH V6 15/21] soc/tegra: pmc: Allow to support more tegras wake
` [PATCH V6 16/21] soc/tegra: pmc: Add pmc wake support for tegra210
` [PATCH V6 17/21] arm64: tegra: Enable wake from deep sleep on RTC alarm
` [PATCH V6 18/21] soc/tegra: pmc: Configure core power request polarity
` [PATCH V6 19/21] soc/tegra: pmc: Configure deep sleep control settings
` [PATCH V6 20/21] arm64: dts: tegra210-p2180: Jetson TX1 SC7 timings
` [PATCH V6 21/21] arm64: dts: tegra210-p3450: Jetson nano "
[PATCH] thermal: tegra: Fix a typo
2019-07-21 16:33 UTC
[PATCH] trace: fix header include guards
2019-07-20 10:39 UTC
[PATCH v4 00/24] More improvements for Tegra30 devfreq driver
2019-07-19 17:52 UTC (91+ messages)
` [PATCH v4 01/24] PM / devfreq: tegra30: Change irq type to unsigned int
` [PATCH v4 02/24] PM / devfreq: tegra30: Keep interrupt disabled while governor is stopped
` [PATCH v4 03/24] PM / devfreq: tegra30: Handle possible round-rate error
` [PATCH v4 04/24] PM / devfreq: tegra30: Drop write-barrier
` [PATCH v4 06/24] PM / devfreq: tegra30: Tune up boosting thresholds
` [PATCH v4 07/24] PM / devfreq: tegra30: Use CPUFreq notifier
` [PATCH v4 08/24] PM / devfreq: tegra30: Move clk-notifier's registration to governor's start
` [PATCH v4 09/24] PM / devfreq: tegra30: Reset boosting on startup
` [PATCH v4 10/24] PM / devfreq: tegra30: Don't enable consecutive-down interrupt "
` [PATCH v4 11/24] PM / devfreq: tegra30: Add debug messages
` [PATCH v4 12/24] PM / devfreq: tegra30: Inline all one-line functions
` [PATCH v4 13/24] PM / devfreq: tegra30: Constify structs
` [PATCH v4 14/24] PM / devfreq: tegra30: Ensure that target freq won't overflow
` [PATCH v4 15/24] PM / devfreq: tegra30: Fix integer overflow on CPU's freq max out
` [PATCH v4 17/24] PM / devfreq: tegra30: Use tracepoints for debugging
` [PATCH v4 18/24] PM / devfreq: tegra30: Optimize CPUFreq notifier
` [PATCH v4 19/24] PM / devfreq: tegra30: Optimize upper consecutive watermark selection
` [PATCH v4 24/24] PM / devfreq: tegra20/30: Add Dmitry as a maintainer
` [PATCH v4 22/24] PM / devfreq: tegra30: Include appropriate header
` [PATCH v4 23/24] PM / devfreq: tegra30: Increase sampling period to 16ms
` [PATCH v4 21/24] PM / devfreq: tegra30: Synchronize average count on target's update
` [PATCH v4 05/24] PM / devfreq: tegra30: Set up watermarks properly
` [PATCH v4 20/24] PM / devfreq: tegra30: Optimize upper average watermark selection
[PATCH AUTOSEL 4.14 41/60] PCI: tegra: Enable Relaxed Ordering only for Tegra20 & Tegra30
2019-07-19 13:53 UTC (4+ messages)
[PATCH net-next 3/3] net: stmmac: Introducing support for Page Pool
2019-07-19 13:35 UTC (14+ messages)
[PATCH] Input: keyboard: Use dev_get_drv_data
2019-07-19 10:51 UTC
[PATCH AUTOSEL 4.4 25/35] PCI: tegra: Enable Relaxed Ordering only for Tegra20 & Tegra30
2019-07-19 4:14 UTC
[PATCH AUTOSEL 4.9 33/45] PCI: tegra: Enable Relaxed Ordering only for Tegra20 & Tegra30
2019-07-19 4:12 UTC
[PATCH AUTOSEL 4.19 019/101] gpu: host1x: Increase maximum DMA segment size
2019-07-19 4:06 UTC (2+ messages)
` [PATCH AUTOSEL 4.19 065/101] PCI: tegra: Enable Relaxed Ordering only for Tegra20 & Tegra30
[PATCH AUTOSEL 5.1 030/141] gpu: host1x: Increase maximum DMA segment size
2019-07-19 4:01 UTC (2+ messages)
` [PATCH AUTOSEL 5.1 089/141] PCI: tegra: Enable Relaxed Ordering only for Tegra20 & Tegra30
[PATCH AUTOSEL 5.2 040/171] gpu: host1x: Increase maximum DMA segment size
2019-07-19 3:55 UTC (2+ messages)
` [PATCH AUTOSEL 5.2 115/171] PCI: tegra: Enable Relaxed Ordering only for Tegra20 & Tegra30
[RFC PATCH] Docs: move more driver,device related docs into drivers dir follows kernel source
2019-07-19 2:14 UTC (2+ messages)
[PATCH V5 00/18] SC7 entry and exit support for Tegra210
2019-07-18 23:52 UTC (69+ messages)
` [PATCH V5 11/18] clk: tegra210: Add support for Tegra210 clocks
[PATCH v1] soc/tegra: pmc: Query PCLK clock rate at probe time
2019-07-18 18:24 UTC (5+ messages)
[PATCH 5.2 00/21] 5.2.2-stable review
2019-07-18 9:37 UTC (2+ messages)
[PATCH 5.1 00/54] 5.1.19-stable review
2019-07-18 9:21 UTC
[PATCH 4.19 00/47] 4.19.60-stable review
2019-07-18 9:20 UTC
[PATCH 4.14 00/80] 4.14.134-stable review
2019-07-18 9:20 UTC
[PATCH 4.9 00/54] 4.9.186-stable review
2019-07-18 9:20 UTC
[PATCH 4.4 00/40] 4.4.186-stable review
2019-07-18 9:19 UTC
[PATCH V3] cpufreq: Make cpufreq_generic_init() return void
2019-07-18 8:47 UTC (2+ messages)
[PATCH v1 1/2] clk: tegra: divider: Fix missing check for enable-bit on rate's recalculation
2019-07-17 21:33 UTC (3+ messages)
[PATCH V13 00/12] PCI: tegra: Add Tegra194 PCIe support
2019-07-16 19:00 UTC (8+ messages)
` [PATCH V13 12/12] "
[PATCH v1] drm/modes: Don't apply cmdline's rotation if it wasn't specified
2019-07-16 14:02 UTC (5+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox