Re: [PATCH 1/3] ALSA: hda/tegra: Skip reset on BPMP devices

[Sameer Pujar <spujar@nvidia.com>]

On 12/14/2021 7:26 PM, Dmitry Osipenko wrote:
> 14.12.2021 10:22, Sameer Pujar пишет:
> ...
>>>> How the reset behavior is different? At this point when HDA driver is
>>>> loaded the HW is already reset during display ungate. What matters,
>>>> during HDA driver load, is whether the HW is in predictable state or not
>>>> and the answer is yes. So I am not sure what problem you are referring
>>>> to. Question is, if BPMP already ensures this, then why driver needs to
>>>> take care of it.
>>> 1. Enable display
>>> 2. Play audio over HDMI
>>> 3. HDA hardware now is in dirty state
>> Why this would be a dirty state? It is rather a functional state. Isn't
>> it? Power-domain is ON while all this happens.
> In general state should be a functional, but we shouldn't assume that.
> There is always a possibility for a subtle bug in a driver that may put
> h/w into a bad state. Full hardware reset is encouraged by users.

OK. I will prepare a v2 by just skipping the invalid reset for Tegra194.


>
>> Another point is, with present logic the reset is not applied for every
>> runtime PM resume of HDA device, which is confusing. It depends on the
>> state of 'chip->running' flag and I don't see this getting cleared
>> anywhere. Would you say subsequent HDA playback happen under a dirty state?
> This is a good point. There should be another potential problem in the
> HDA driver for newer SoCs because apparently we don't re-initialize HDA
> controller properly after runtime PM resume.
>
> See hda_tegra_first_init() that is invoked only during driver probe, it
> configures FPCI_DBG_CFG_2 register on T194, which isn't done by
> hda_tegra_init(), and thus, this register may be  in reset state after
> resume from RPM suspend. It should be a bug in the HDA driver that needs
> to be fixed.
>
> On older SoCs: HDA resides in the APB power domain which could be
> disabled only across system suspend/resume. HDA is only clock-gated
> during runtime PM suspend.
>
> On newer SoCs: HDA power state could be lost after RPM suspend/resume,
> depending on the state of display. I'm wondering whether HDMI playback
> works after DPMS on T194+, I assume this case was never tested properly.
>
> It looks like it should be safe to reset HDA on runtime PM resume
> regardless of the chip->running, and thus, we could remove that check
> and reset HDA unconditionally. Will great if you could check/test and
> improve this in the driver.

There seems to be multiple issues. I will work on this separately and 
send a separate series. Presently basic function is broken on Tegra194 
and will first send v2 to fix the regression. Thanks for review.