[2/6] xhci: Don't print a warning when setting link state for disabled ports

[Mathias Nyman <mathias.nyman@linux.intel.com>]

When disabling a USB3 port the hub driver will set the port link state to
U3 to prevent "ejected" or "safely removed" devices that are still
physically connected from immediately re-enumerating.

If the device was really unplugged, then error messages were printed
as the hub tries to set the U3 link state for a port that is no longer
enabled.

xhci-hcd ee000000.usb: Cannot set link state.
usb usb8-port1: cannot disable (err = -32)

Don't print error message in xhci-hub if hub tries to set port link state
for a disabled port. Return -ENODEV instead which also silences hub driver.

Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
---
 drivers/usb/host/xhci-hub.c | 18 +++++++++---------
 1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/drivers/usb/host/xhci-hub.c b/drivers/usb/host/xhci-hub.c
index 1df0c36..72ebbc9 100644
--- a/drivers/usb/host/xhci-hub.c
+++ b/drivers/usb/host/xhci-hub.c
@@ -1224,17 +1224,17 @@ int xhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue,
 				temp = readl(port_array[wIndex]);
 				break;
 			}
-
-			/* Software should not attempt to set
-			 * port link state above '3' (U3) and the port
-			 * must be enabled.
-			 */
-			if ((temp & PORT_PE) == 0 ||
-				(link_state > USB_SS_PORT_LS_U3)) {
-				xhci_warn(xhci, "Cannot set link state.\n");
+			/* Port must be enabled */
+			if (!(temp & PORT_PE)) {
+				retval = -ENODEV;
+				break;
+			}
+			/* Can't set port link state above '3' (U3) */
+			if (link_state > USB_SS_PORT_LS_U3) {
+				xhci_warn(xhci, "Cannot set port %d link state %d\n",
+					 wIndex, link_state);
 				goto error;
 			}
-
 			if (link_state == USB_SS_PORT_LS_U3) {
 				slot_id = xhci_find_slot_id_by_port(hcd, xhci,
 						wIndex + 1);