Hi Mika, On Mon, Nov 09, 2026 at 03:20:41PM +0100, Mika Westerberg wrote: > Please drop thunderbolt.host_reset=0 and pcie_aspm=off. The later disables > much more than just ASPM so it may affect everything. Once you have done > that please take another dmesg (and check also the link registers via > tbdump). Done. I rebooted with both parameters removed. The only addition is thunderbolt.dyndbg=+p so the full debug output is in the log: nohibernate root=fstab loglevel=4 lsm=landlock,yama,bpf usb-storage.quirks=0bc2:3343:u thunderbolt.dyndbg=+p The result is the same as before: the link still comes up as TBT at 10 Gb/s x2 (the dmesg has "2: link: TBT" and "current link speed 10.0 Gb/s"), and the lane adapter registers are identical to my previous dump. The host lane adapter targets Gen 3, the DEG2 targets Gen 4, and both report Current Link Speed = Gen 2, x2. The full dmesg from this boot is attached (gzipped). The tbdump output is below. # cmdline: initrd=\EFI\nixos\c18phgd1m2qpc2g72pz14fg9h9i38j6w-initrd-linux-7.2.15-initrd.efi init=/nix/store/x1jyvpbgdhl6a91iysmbr5wisgi0sghd-nixos-system-nyx-26.11.20261106.4fe25e1/init usb-storage.quirks=0bc2:3343:u nohibernate root=fstab loglevel=4 lsm=landlock,yama,bpf thunderbolt.dyndbg=+p # 1-2 rx=10.0 Gb/s x2 tx=10.0 Gb/s x2 # usb4_port link: none tbt tbt none none none $ tbdump -d 1 -r 0 -a 2 -N 2 -vv LANE_ADP_CS_0 0x0080 0x003c01c0 0b00000000 00111100 00000001 11000000 .<.. LANE_ADP_CS_0 [00:07] 0xc0 Next Capability Pointer [08:15] 0x1 Capability ID [16:19] 0xc Supported Link Speeds [20:21] 0x3 Supported Link Widths (SLW) [22:23] 0x0 Gen 4 Asymmetric Support (G4AS) [26:26] 0x0 CL0s Support [27:27] 0x0 CL1 Support [28:28] 0x0 CL2 Support 0x0081 0x4828003c 0b01001000 00101000 00000000 00111100 H(.< LANE_ADP_CS_1 [00:03] 0xc Target Link Speed → Router shall attempt Gen 3 speed [04:05] 0x3 Target Link Width → Establish a Symmetric Link [06:07] 0x0 Target Asymmetric Link → Establish Symmetric Link [10:10] 0x0 CL0s Enable [11:11] 0x0 CL1 Enable [12:12] 0x0 CL2 Enable [14:14] 0x0 Lane Disable (LD) [15:15] 0x0 Lane Bonding (LB) [16:19] 0x8 Current Link Speed → Gen 2 [20:25] 0x2 Negotiated Link Width → Symmetric Link (x2) [26:29] 0x2 Adapter State → CL0 [30:30] 0x1 PM Secondary (PMS) $ tbdump -d 1 -r 2 -a 1 -N 2 -vv LANE_ADP_CS_0 0x0036 0x0cfe01c0 0b00001100 11111110 00000001 11000000 .... LANE_ADP_CS_0 [00:07] 0xc0 Next Capability Pointer [08:15] 0x1 Capability ID [16:19] 0xe Supported Link Speeds [20:21] 0x3 Supported Link Widths (SLW) [22:23] 0x3 Gen 4 Asymmetric Support (G4AS) [26:26] 0x1 CL0s Support [27:27] 0x1 CL1 Support [28:28] 0x0 CL2 Support 0x0037 0x4828003e 0b01001000 00101000 00000000 00111110 H(.> LANE_ADP_CS_1 [00:03] 0xe Target Link Speed → Router shall attempt Gen 4 speed [04:05] 0x3 Target Link Width → Establish a Symmetric Link [06:07] 0x0 Target Asymmetric Link → Establish Symmetric Link [10:10] 0x0 CL0s Enable [11:11] 0x0 CL1 Enable [12:12] 0x0 CL2 Enable [14:14] 0x0 Lane Disable (LD) [15:15] 0x0 Lane Bonding (LB) [16:19] 0x8 Current Link Speed → Gen 2 [20:25] 0x2 Negotiated Link Width → Symmetric Link (x2) [26:29] 0x2 Adapter State → CL0 [30:30] 0x1 PM Secondary (PMS) $ tbdump -d 1 -r 2 -a 2 -N 2 -vv LANE_ADP_CS_0 0x0036 0x0cfe0100 0b00001100 11111110 00000001 00000000 .... LANE_ADP_CS_0 [00:07] 0x0 Next Capability Pointer [08:15] 0x1 Capability ID [16:19] 0xe Supported Link Speeds [20:21] 0x3 Supported Link Widths (SLW) [22:23] 0x3 Gen 4 Asymmetric Support (G4AS) [26:26] 0x1 CL0s Support [27:27] 0x1 CL1 Support [28:28] 0x0 CL2 Support 0x0037 0x4828003e 0b01001000 00101000 00000000 00111110 H(.> LANE_ADP_CS_1 [00:03] 0xe Target Link Speed → Router shall attempt Gen 4 speed [04:05] 0x3 Target Link Width → Establish a Symmetric Link [06:07] 0x0 Target Asymmetric Link → Establish Symmetric Link [10:10] 0x0 CL0s Enable [11:11] 0x0 CL1 Enable [12:12] 0x0 CL2 Enable [14:14] 0x0 Lane Disable (LD) [15:15] 0x0 Lane Bonding (LB) [16:19] 0x8 Current Link Speed → Gen 2 [20:25] 0x2 Negotiated Link Width → Symmetric Link (x2) [26:29] 0x2 Adapter State → CL0 [30:30] 0x1 PM Secondary (PMS) $ tbadapters -d 1 -r 0 1: Host Interface (upstream) Enabled 2: Lane 0 CL0 3: Lane 0 CL0 4: USB 3 Down Disabled 5: PCIe Down L0 6: DisplayPort IN Disabled 7: DisplayPort IN Disabled $ tbadapters -d 1 -r 2 1: Lane 0 (upstream) CL0 2: Lane 1 CL0 3: Lane 0 CLd 4: Lane 1 CLd 5: Lane 0 CLd 6: Lane 1 CLd 7: Lane 0 CLd 8: Lane 1 CLd 9: PCIe Up L0 10: PCIe Down Disabled 11: DisplayPort OUT Disabled 12: DisplayPort OUT Disabled 13: Not implemented 14: Not implemented 15: Not implemented 16: Not implemented 17: PCIe Down Disabled 18: PCIe Down Disabled 19: DisplayPort OUT Disabled 20: USB 3 Up Disabled 21: USB 3 Down Disabled 22: USB 3 Down Disabled 23: USB 3 Down Disabled Thanks, James