[RFC/PATCH 2/2] phy: rockchip: usbdp: implement .set_mode

[John Keeping <jkeeping@inmusicbrands.com>]

When the orientation of a type C cable changes, usbdp set the new
configuration in its internal state but does not write this to the
hardware.

Make use of phy_ops::set_mode to write this new state.  This should be
called by the USB controller when it is notified of a role change
(assuming it is acting as the role switch) and will be called at a point
when the controller does not expect the phy to be operating normally.

Signed-off-by: John Keeping <jkeeping@inmusicbrands.com>
---
 drivers/phy/rockchip/phy-rockchip-usbdp.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/phy/rockchip/phy-rockchip-usbdp.c b/drivers/phy/rockchip/phy-rockchip-usbdp.c
index c066cc0a7b4f1..00368fb09307a 100644
--- a/drivers/phy/rockchip/phy-rockchip-usbdp.c
+++ b/drivers/phy/rockchip/phy-rockchip-usbdp.c
@@ -1335,9 +1335,23 @@ static int rk_udphy_usb3_phy_exit(struct phy *phy)
 	return 0;
 }
 
+static int rk_udphy_usb3_phy_set_mode(struct phy *phy, enum phy_mode mode, int submode)
+{
+	struct rk_udphy *udphy = phy_get_drvdata(phy);
+	int ret = 0;
+
+	mutex_lock(&udphy->mutex);
+	if (udphy->mode != UDPHY_MODE_NONE)
+		ret = rk_udphy_init(udphy);
+	mutex_unlock(&udphy->mutex);
+
+	return ret;
+}
+
 static const struct phy_ops rk_udphy_usb3_phy_ops = {
 	.init		= rk_udphy_usb3_phy_init,
 	.exit		= rk_udphy_usb3_phy_exit,
+	.set_mode	= rk_udphy_usb3_phy_set_mode,
 	.owner		= THIS_MODULE,
 };
 
-- 
2.50.0