Linux USB
 help / color / mirror / Atom feed
From: Michal Pecio <michal.pecio@gmail.com>
To: Desnes Nunes <desnesn@redhat.com>,
	David Woodhouse <dwmw2@infradead.org>,
	Lu Baolu <baolu.lu@linux.intel.com>
Cc: linux-kernel@vger.kernel.org, linux-usb@vger.kernel.org,
	gregkh@linuxfoundation.org, mathias.nyman@intel.com,
	stable@vger.kernel.org, iommu@lists.linux.dev
Subject: Re: [PATCH RFT RFC] usb: xhci: Kill hosts with HCE or HSE on command timeout
Date: Wed, 27 May 2026 10:32:21 +0200	[thread overview]
Message-ID: <20260527103221.7f8b15b0.michal.pecio@gmail.com> (raw)
In-Reply-To: <CACaw+ezMnQh2_oqbZ0jF99+wOADMU2vSMqxh9BoJoefjAC_ixw@mail.gmail.com>

Adding Intel IOMMU people.

Context:

Desnes reported xHCI issues duing crash kernel boot after SysRq
triggered panic. Turns out, the chip gets an IOMMU fault, some other
devices also do. Faulting address is a successful dma_alloc_coherent()
allocation in xhci_alloc_erst(), no evidence that it's freed before
the fault occurs. No problems during normal boot.

On Wed, 27 May 2026 00:47:53 -0300, Desnes Nunes wrote:
> # grep "alloc ERST\|free ERST\|ERST\|Device context\|fault addr" kexec-dmesg.log
> [Tue May 26 08:41:56 2026] DMAR: [DMA Write NO_PASID] Request device
> [80:1f.6] fault addr 0x106f06000 [fault reason 0x39] SM: Present bit
> in Root Entry is clear
> [Tue May 26 08:41:56 2026] DMAR: [DMA Write NO_PASID] Request device
> [80:1f.6] fault addr 0x106f19000 [fault reason 0x39] SM: Present bit
> in Root Entry is clear
> [Tue May 26 08:41:57 2026] DMAR: [DMA Write NO_PASID] Request device
> [80:1f.6] fault addr 0x106f1c000 [fault reason 0x39] SM: Present bit
> in Root Entry is clear
> [...]
> [Tue May 26 08:42:01 2026] xhci_hcd 0000:80:14.0: alloc ERST at
> 0x0000001075140000
> [Tue May 26 08:42:01 2026] xhci_hcd 0000:80:14.0: ERST deq = 64'h107513e000
> [Tue May 26 08:42:02 2026] DMAR: [DMA Read NO_PASID] Request device
> [80:14.0] fault addr 0x1075140000 [fault reason 0x39] SM: Present bit
> in Root Entry is clear
> 
> ^ PS: Different address alloc on kdump though
> 
> > Otherwise, it seems you were right that you have some IOMMU problem.  
> 
> Thus, I started to investigate this front now. This time I gave some
> more attention to these dmar messages:
> 
>      [Tue May 19 08:17:49 2026] DMAR: Intel-IOMMU force enabled due to
> platform opt in
>      [Tue May 19 08:17:49 2026] DMAR: No RMRR found
>      [Tue May 19 08:17:49 2026] DMAR: No ATSR found
>      [Tue May 19 08:17:49 2026] DMAR: dmar0: Using Queued invalidation
> => [Tue May 19 08:17:49 2026] DMAR: Translation already enabled -  
> trying to copy translation structures
> => [Tue May 19 08:17:49 2026] DMAR: Copied translation tables from  
> previous kernel for dmar0
>      [Tue May 19 08:17:49 2026] DMAR: dmar1: Using Queued invalidation
> => [Tue May 19 08:17:49 2026] DMAR: Translation already enabled -  
> trying to copy translation structures
> => [Tue May 19 08:17:49 2026] DMAR: Copied translation tables from  
> previous kernel for dmar1
> 
> I started wondering if maybe on my system these translation tables
> can't be fully trusted for some reason during kdump?
> Maybe iommu is copying root_entries with the Present bit clear, and
> thus generating the fault reason 0x39?
>    -> bus 0x80's? Both ethernet and xhci_hcd fault addr were on this bus  
> 
> So, to test this theory out, I tried to disable translation and
> allocate a clean root-entry table right away if I am running a kdump
> kernel:
> 
> diff --git a/drivers/iommu/intel/iommu.c b/drivers/iommu/intel/iommu.c
> index e236c7ec221f..de673f34f4e1 100644
> --- a/drivers/iommu/intel/iommu.c
> +++ b/drivers/iommu/intel/iommu.c
> @@ -2135,24 +2135,31 @@ static int __init init_dmars(void)
>                 if (translation_pre_enabled(iommu)) {
>                         pr_info("Translation already enabled - trying
> to copy translation structures\n");
> 
> -                       ret = copy_translation_tables(iommu);
> -                       if (ret) {
> -                               /*
> -                                * We found the IOMMU with translation
> -                                * enabled - but failed to copy over the
> -                                * old root-entry table. Try to proceed
> -                                * by disabling translation now and
> -                                * allocating a clean root-entry table.
> -                                * This might cause DMAR faults, but
> -                                * probably the dump will still succeed.
> -                                */
> -                               pr_err("Failed to copy translation
> tables from previous kernel for %s\n",
> -                                      iommu->name);
> +                       if (is_kdump_kernel()) {
> +                               pr_info("DESNES V2 IOMMU kdump kernel,
> disabilng translation and allocating clean root-entry for %s\n",
> +                                       iommu->name);
>                                 iommu_disable_translation(iommu);
>                                 clear_translation_pre_enabled(iommu);
>                         } else {
> -                               pr_info("Copied translation tables
> from previous kernel for %s\n",
> -                                       iommu->name);
> +                               ret = copy_translation_tables(iommu);
> +                               if (ret) {
> +                                       /*
> +                                        * We found the IOMMU with translation
> +                                        * enabled - but failed to copy over the
> +                                        * old root-entry table. Try to proceed
> +                                        * by disabling translation now and
> +                                        * allocating a clean root-entry table.
> +                                        * This might cause DMAR faults, but
> +                                        * probably the dump will still succeed.
> +                                        */
> +                                       pr_err("DESNES V2 Failed to
> copy translation tables from previous kernel for %s\n",
> +                                              iommu->name);
> +                                       iommu_disable_translation(iommu);
> +                                       clear_translation_pre_enabled(iommu);
> +                               } else {
> +                                       pr_info("DESNES V2 Copied
> translation tables from previous kernel for %s\n",
> +                                               iommu->name);
> +                               }
>                         }
>                 }
> 
> Didn't had time to check ERST or HSE yet, but with this I didn't had
> any DMAR faults, vmcore was collected normally and system rebooted
> smoothly afterwards:
> 
>      [Tue May 26 22:52:58 2026] DMAR: Intel-IOMMU force enabled due to
> platform opt in
>      [Tue May 26 22:52:58 2026] DMAR: No RMRR found
>      [Tue May 26 22:52:58 2026] DMAR: No ATSR found
>      [Tue May 26 22:52:58 2026] DMAR: dmar0: Using Queued invalidation
> => [Tue May 26 22:52:58 2026] DMAR: Translation already enabled -  
> trying to copy translation structures
> => [Tue May 26 22:52:58 2026] DMAR: DESNES V2 IOMMU kdump kernel,  
> disabilng translation and allocating clean root-entry for dmar0
>      [Tue May 26 22:52:58 2026] DMAR: dmar1: Using Queued invalidation
> => [Tue May 26 22:52:58 2026] DMAR: Translation already enabled -  
> trying to copy translation structures
> => [Tue May 26 22:52:58 2026] DMAR: DESNES V2 IOMMU kdump kernel,  
> disabilng translation and allocating clean root-entry for dmar1
> 
> Seems like a lead on this iommu front.
> 
> The funny thing is that the comment in this section literaly says that
> doing this could cause faults, but here clearing it actually seemed to
> solve them and made kdump succeed - commit
> 091d42e43d21b6ca7ec39bf5f9e17bc0bd8d4312 ("iommu/vt-d: Copy
> translation tables from old kernel")
> 
> Let me do some more tests to dump and check the root-entry table
> before clearing, as well as to check ERST allocations and HSE value,
> and I'll get back to you Michal.
> 
> Best Regards,
> 
> Desnes
> 

  reply	other threads:[~2026-05-27  8:32 UTC|newest]

Thread overview: 25+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-04-30  1:48 [PATCH] usb: xhci: bound wait command completion to avoid kdump deadlock Desnes Nunes
2026-04-30  8:48 ` Michal Pecio
2026-04-30 17:27   ` Desnes Nunes
2026-04-30 21:54     ` Michal Pecio
2026-05-01 14:09       ` Desnes Nunes
2026-05-02  9:46         ` [PATCH RFT RFC] usb: xhci: Kill hosts with HCE or HSE on command timeout Michal Pecio
2026-05-02 11:38           ` Desnes Nunes
2026-05-02 21:55             ` Michal Pecio
2026-05-03  3:36               ` Desnes Nunes
2026-05-03  5:17                 ` Michal Pecio
2026-05-03 16:20                   ` Desnes Nunes
2026-05-03 19:31                     ` Michal Pecio
2026-05-04  7:31                       ` Michal Pecio
2026-05-18  6:33                         ` Michal Pecio
2026-05-20  4:59                           ` Desnes Nunes
2026-05-22  9:03                             ` Michal Pecio
2026-05-22 20:45                               ` Desnes Nunes
2026-05-23  0:29                                 ` Michal Pecio
2026-05-23  3:47                                   ` Desnes Nunes
2026-05-23  8:28                                     ` Michal Pecio
2026-05-27  3:47                                       ` Desnes Nunes
2026-05-27  8:32                                         ` Michal Pecio [this message]
2026-06-10 15:32                                           ` Desnes Nunes
2026-06-18  0:57                                             ` Desnes Nunes
2026-06-18  4:46                                               ` Intel IOMMU bug: xHCI faults during crash kernel boot Michal Pecio

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20260527103221.7f8b15b0.michal.pecio@gmail.com \
    --to=michal.pecio@gmail.com \
    --cc=baolu.lu@linux.intel.com \
    --cc=desnesn@redhat.com \
    --cc=dwmw2@infradead.org \
    --cc=gregkh@linuxfoundation.org \
    --cc=iommu@lists.linux.dev \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-usb@vger.kernel.org \
    --cc=mathias.nyman@intel.com \
    --cc=stable@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox