Re: [PATCH 0/5] Add support for Battery Status & Battery Caps AMS in TCPM

[Amit Sunil Dhamne <amitsd@google.com>]

On 3/21/25 12:51 AM, Krzysztof Kozlowski wrote:
> On 20/03/2025 22:11, Amit Sunil Dhamne wrote:
>> On 3/16/25 9:52 AM, Krzysztof Kozlowski wrote:
>>> On 15/03/2025 01:49, Amit Sunil Dhamne wrote:
>>>> Hi Krzysztof,
>>>>
>>>> Thanks for the review!
>>>>
>>>> On 3/13/25 1:50 AM, Krzysztof Kozlowski wrote:
>>>>> On Wed, Mar 12, 2025 at 04:42:00PM -0700, Amit Sunil Dhamne wrote:
>>>>>> Support for Battery Status & Battery Caps messages in response to
>>>>>> Get_Battery_Status & Get_Battery_Cap request is required by USB PD devices
>>>>>> powered by battery, as per "USB PD R3.1 V1.8 Spec", "6.13 Message
>>>>>> Applicability" section. This patchset adds support for these AMSes
>>>>>> to achieve greater compliance with the spec.
>>>>> Which board uses it? I would be happy to see that connection between
>>>>> batteries and USB connector on the schematics of some real device. How
>>>>> does it look like?
>>>> Any board that uses a USB Type-C connector that supplies power into or
>>> If you keep responding like this, you will got nowhere, so let me
>>> re-iterate:
>>>
>>> Which upstream DTS (or upstream supported hardware) is going to use this
>>> binding, so I can see how you are going to implement it there in the
>>> entire system?
>> This is for maxim,max33359 Type-C controller.
> Stop deflecting the questions. max33359 is not a board. I already asked
> two times.
>
> Apparently admitting "no upstream users" is impossible, so let's state
> the obvious:
>
> There are no upstream users of this.

max33359 controller has an upstream user i.e., gs101-oriole (Pixel 6) 
board. Totally agree that at the moment there are no upstream 
devices/drivers for the Fuel Gauge (that my patchset has a dependency 
on) in gs101-oriole board. gs101-oriole uses max77759 fuel gauge device. 
I see that there's an effort for upstreaming it 
(https://lore.kernel.org/all/20250102-b4-gs101_max77759_fg-v2-0-87959abeb7ff@uclouvain.be/). 
I will mark my patches as dependent on it + demonstrate the relationship 
of the devices in the gs101-oriole board. Hope that's okay?


Thanks,

Amit

>> This would property would have been present for the connector present in
>> the typec device for gs101-oriole board (that uses the max33359
>> controller).
>
> But it is not.
>
>
>> However, I will be exploring existing bindings to describe the
>> relationship for now.
>>
>>>> out of a battery while operating in sink or source mode respectively.
>>>> The VBUS is connected to the (battery + buck boost IC's CHGin/Vin) or a
>>>> companion IFPMIC connected to a battery.  In our board we have USB
>>>> Connector <-> IFPMIC <-> Battery.
>>> Which board is that?
>> gs101-oriole board.
>
> Then why this is not used? The board was released some years ago, so I
> do not see a problem in using it.
>
> Best regards,
> Krzysztof