Re: [PATCH v9 0/3] arm64: meson: Add support for USB on Amlogic A1

[Kevin Hilman <khilman@baylibre.com>]

Kishon,

Hanjie Lin <hanjie.lin@amlogic.com> writes:

> This patchset adds support for USB on Amlogic A1 SoCs.
>
> Because of my mistake I fogot to add PHY maintainer(Kishon) to mail list in
> before versions, so I have to send this v8(and lateres) version again(only with dwc3
> bindings and driver patch removed).
>
> This patchset is composed with :
> - bindings of the PHY
> - bindings of the USB Control Glue(already accepted in v7)
> - PHY Driver
> - USB Control Glue driver(already accepted in v7)
> - dts of the PHY and USB Controller
>
> The Amlogic A1 USB Complex is composed of :
> - 1 DWC3 USB controller for USB2 Host functionality
> - 1 USB2 PHY for USB2 Host functionality
>
> The USB Control Glue setups the clocks and the reset about DWC3 USB
> controller, and binds to the USB2 PHY. It also configures the 8bit
> UTMI interfaces for the USB2 PHY, including setting USB2 phy mode.
>
> The USB2 PHY driver initializes the phy analog settings, phy PLL 
> setup and phy tuning.
>
> This patchset is based on A1 clock/power domain/reset series at [0].

Gentle reminder ping.

Once you pick up the bindings and driver (patches 1-2) I'll pick up the
DT patch.

Kevin