[v2,2/2] usb: dwc3: add dual role support using OTG block

[Felipe Balbi <balbi@kernel.org>]

Roger Quadros <rogerq@ti.com> writes:

> This is useful on platforms (e.g. TI AM437x) that don't
> have ID available on a GPIO but do have the OTG block.
>
> We can obtain the ID state via the OTG block and use it
> for dual-role switching.
>
> Signed-off-by: Roger Quadros <rogerq@ti.com>

patch one applied fine to testing/next. But not this one:

checking file drivers/usb/dwc3/core.c
Hunk #2 FAILED at 107.
Hunk #3 succeeded at 122 (offset -5 lines).
Hunk #4 succeeded at 166 (offset -3 lines).
Hunk #5 succeeded at 365 (offset 5 lines).
Hunk #6 succeeded at 382 (offset 5 lines).
Hunk #7 succeeded at 1193 with fuzz 2 (offset -145 lines).
Hunk #8 FAILED at 1383.
2 out of 8 hunks FAILED
checking file drivers/usb/dwc3/core.h
Hunk #2 succeeded at 901 (offset 33 lines).
Hunk #3 succeeded at 1040 (offset 35 lines).
Hunk #4 succeeded at 1316 (offset 46 lines).
Hunk #5 succeeded at 1334 (offset 46 lines).
Hunk #6 succeeded at 1380 (offset 46 lines).
checking file drivers/usb/dwc3/drd.c

care to rebase?