Re: [PATCH v7 3/4] arm64: dts: qcom: sc7280: Add PCIe nodes for IDP board

[Bjorn Andersson <bjorn.andersson@linaro.org>]

On Tue 14 Sep 18:13 PDT 2021, Stephen Boyd wrote:

> Quoting Prasad Malisetty (2021-09-14 11:19:09)
> > Enable PCIe controller and PHY for sc7280 IDP board.
> > Add specific NVMe GPIO entries for SKU1 and SKU2 support.
> >
> > Signed-off-by: Prasad Malisetty <pmaliset@codeaurora.org>
> > ---
> >  arch/arm64/boot/dts/qcom/sc7280-idp.dts  |  9 +++++++++
> >  arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 32 ++++++++++++++++++++++++++++++++
> >  arch/arm64/boot/dts/qcom/sc7280-idp2.dts |  9 +++++++++
> >  3 files changed, 50 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/qcom/sc7280-idp.dts b/arch/arm64/boot/dts/qcom/sc7280-idp.dts
> > index 64fc22a..2cc6b0a 100644
> > --- a/arch/arm64/boot/dts/qcom/sc7280-idp.dts
> > +++ b/arch/arm64/boot/dts/qcom/sc7280-idp.dts
> > @@ -61,6 +61,15 @@
> >         modem-init;
> >  };
> >
> > +&pcie1_default_state {
> > +       nvme-n {
> > +               pins = "gpio19";
> > +               function = "gpio";
> > +
> > +               bias-pull-up;
> > +       };
> 
> I don't think the style is to have a single container node anymore.
> Instead, each pin gets a different node and then pinctrl-0 has a list of
> phandles to the different nodes. qcom maintainers may have more input
> here.
> 

Having a container that defines the state and each part thereof is
preferred (see other PCIe users or how we typically define the Bluetooth
UART). But is "nvme_n" really part of the "PCI state" or is this related
to the NVME device instead?

> Also, this should really go into a different section than here. I
> thought the style was to have a 'board specific' pinctrl section.
> 

Yes, pushing pinctrl states to the bottom is preferred and rather than
amending the existing state I think this goes in a state of its own and
the pinctrl-N amended to include this new state as well.

Regards,
Bjorn

> > +};
> > +
> >  &pmk8350_vadc {
> >         pmr735a_die_temp {
> >                 reg = <PMR735A_ADC7_DIE_TEMP>;