Re: [PATCH v1 2/6] usb: chipidea: tegra: Avoid controller/PHY init if bus is externally controlled

["Peter Chen (CIX)" <peter.chen@kernel.org>]

On 26-05-13 20:30:10, Svyatoslav Ryhel wrote:
> вт, 12 трав. 2026 р. о 10:51 Peter Chen (CIX) <peter.chen@kernel.org> пише:
> >
> > On 26-05-12 09:13:40, Svyatoslav Ryhel wrote:
> > > вт, 12 трав. 2026 р. о 04:16 Peter Chen (CIX) <peter.chen@kernel.org> пише:
> > > >
> > > > On 26-05-11 16:56:57, Svyatoslav Ryhel wrote:
> > > > > If the USB controller and PHY are externally controlled, then the
> > > > > registration of the controller and the PHY initialization should be
> > > > > skipped, since these configurations must be done by the device that
> > > > > controls the bus to work correctly.
> > > > >
> > > >
> > > > I find you only control USB controller device add at PHY driver, most of USB drivers
> > > > has PHY control, for chipidea, it has PHY control at core.c, would please try to
> > > > adapt for it?
> > > >
> > >
> > > Usually yes, but this is not the case for Tegra unfortunately. As you
> > > can see Tegra specific section of Chipidea driver specifically
> > > describes why it has to set PHY manually.
> > >
> > > /*
> > >  * USB controller registers shouldn't be touched before PHY is
> > >  * initialized, otherwise CPU will hang because clocks are gated.
> > >  * PHY driver controls gating of internal USB clocks on Tegra.
> > >  */
> > >
> > > So in order to provide correct work of USB when set by an external
> > > device, both PHY and controller init/add must be skipped.
> >
> > You could call generic PHY APIs at ci_hdrc_tegra.c, after PHY init or power on,
> > call controller initialization.
> >
> 
> I was tinkering with Chipidea driver for Tegra a bit. If you meant to
> use flag only to control usb controller device init and leave PHY to
> be handled by controller, then yes, that is possible and that is
> better approach.
> 

Yes, you may summarize the initialization sequence, and see if put PHY
control at Tegra glue layer or at Chipidea core.

-- 

Best regards,
Peter