From: bugzilla-daemon@bugzilla.kernel.org
To: linux-usb@vger.kernel.org
Subject: [Bug 206649] Lenovo C940 - USB3 disk not detected if connected after boot - no space for [mem size 0x00010000]
Date: Sun, 23 Feb 2020 22:32:39 +0000 [thread overview]
Message-ID: <bug-206649-208809-IO0eX4818h@https.bugzilla.kernel.org/> (raw)
In-Reply-To: <bug-206649-208809@https.bugzilla.kernel.org/>
https://bugzilla.kernel.org/show_bug.cgi?id=206649
A (email-ext@laposte.net) changed:
What |Removed |Added
----------------------------------------------------------------------------
Summary|Lenovo C940 - USB3 disk not |Lenovo C940 - USB3 disk not
|detected if connected after |detected if connected after
|boot |boot - no space for [mem
| |size 0x00010000]
--- Comment #2 from A (email-ext@laposte.net) ---
Here are some complementary dmesg log when plugin back the disk to thunderbolt
port on dock. From the log the following errors occured:
97.075649] usb 12-1: USB disconnect, device number 2
[ 97.076371] sd 1:0:0:0: [sda] Synchronizing SCSI cache
[ 97.092456] pcieport 0000:02:04.0: pciehp: Slot(0-2): Link Down
[ 97.092460] pcieport 0000:02:04.0: pciehp: Slot(0-2): Card not present
[ 97.092466] xhci_hcd 0000:07:00.0: PME# disabled
[ 97.092483] xhci_hcd 0000:07:00.0: remove, state 1
[ 97.092490] usb usb12: USB disconnect, device number 1
[ 97.187858] xhci_hcd 0000:07:00.0: xHCI host controller not responding,
assume dead
[ 97.281395] sd 1:0:0:0: [sda] Synchronize Cache(10) failed: Result:
hostbyte=DID_ERROR driverbyte=DRIVER_OK
[ 97.354815] xhci_hcd 0000:07:00.0: WARN Can't disable streams for endpoint
0x81, streams are being disabled already
[ 97.355682] xhci_hcd 0000:07:00.0: USB bus 12 deregistered
[ 97.355695] xhci_hcd 0000:07:00.0: remove, state 4
[ 97.355700] usb usb11: USB disconnect, device number 1
[ 97.355933] xhci_hcd 0000:07:00.0: Host halt failed, -19
[ 97.355937] xhci_hcd 0000:07:00.0: Host not accessible, reset failed.
[ 97.356817] xhci_hcd 0000:07:00.0: USB bus 11 deregistered
[ 97.357314] pci 0000:07:00.0: Removing from iommu group 3
[ 97.357379] pcieport 0000:02:04.0: saving config space at offset 0x0
(reading 0x15d38086)
[ 97.357384] pcieport 0000:02:04.0: saving config space at offset 0x4
(reading 0x100407)
[ 97.357388] pcieport 0000:02:04.0: saving config space at offset 0x8
(reading 0x6040002)
[ 97.357392] pcieport 0000:02:04.0: saving config space at offset 0xc
(reading 0x10010)
[ 97.357396] pcieport 0000:02:04.0: saving config space at offset 0x10
(reading 0x0)
[ 97.357400] pcieport 0000:02:04.0: saving config space at offset 0x14
(reading 0x0)
[ 97.357405] pcieport 0000:02:04.0: saving config space at offset 0x18
(reading 0x2c0702)
[ 97.357409] pcieport 0000:02:04.0: saving config space at offset 0x1c
(reading 0x1f1)
[ 97.357413] pcieport 0000:02:04.0: saving config space at offset 0x20
(reading 0x5fd05400)
[ 97.357418] pcieport 0000:02:04.0: saving config space at offset 0x24
(reading 0x1bf10001)
[ 97.357422] pcieport 0000:02:04.0: saving config space at offset 0x28
(reading 0x60)
[ 97.357426] pcieport 0000:02:04.0: saving config space at offset 0x2c
(reading 0x60)
[ 97.357430] pcieport 0000:02:04.0: saving config space at offset 0x30
(reading 0x0)
[ 97.357434] pcieport 0000:02:04.0: saving config space at offset 0x34
(reading 0x80)
[ 97.357437] pcieport 0000:02:04.0: saving config space at offset 0x38
(reading 0x0)
[ 97.357441] pcieport 0000:02:04.0: saving config space at offset 0x3c
(reading 0x201ff)
[ 97.357521] pcieport 0000:02:04.0: PME# enabled
[ 134.658112] pcieport 0000:02:04.0: restoring config space at offset 0x2c
(was 0x60, writing 0x60)
[ 134.658120] pcieport 0000:02:04.0: restoring config space at offset 0x28
(was 0x60, writing 0x60)
[ 134.658127] pcieport 0000:02:04.0: restoring config space at offset 0x24
(was 0x1bf10001, writing 0x1bf10001)
[ 134.658239] pcieport 0000:02:04.0: PME# disabled
[ 134.658289] pcieport 0000:02:04.0: pciehp: Slot(0-2): Card present
[ 134.658291] pcieport 0000:02:04.0: pciehp: Slot(0-2): Link Up
[ 134.658304] pcieport 0000:00:07.0: PME: Spurious native interrupt!
[ 134.791395] pci 0000:07:00.0: [8086:15d4] type 00 class 0x0c0330
[ 134.791453] pci 0000:07:00.0: reg 0x10: [mem 0x00000000-0x0000ffff]
[ 134.791548] pci 0000:07:00.0: enabling Extended Tags
[ 134.791760] pci 0000:07:00.0: supports D1 D2
[ 134.791762] pci 0000:07:00.0: PME# supported from D0 D1 D2 D3hot D3cold
[ 134.791771] pci 0000:07:00.0: PME# disabled
[ 134.791897] pci 0000:07:00.0: 8.000 Gb/s available PCIe bandwidth, limited
by 2.5 GT/s x4 link at 0000:00:07.0 (capable of 31.504 Gb/s with 8 GT/s x4
link)
[ 134.792031] pci 0000:07:00.0: Adding to iommu group 3
[ 134.792033] pci 0000:07:00.0: DMAR: Use Intel IOMMU bounce page dma_ops
[ 134.792144] pcieport 0000:02:04.0: ASPM: current common clock configuration
is broken, reconfiguring
[ 134.792214] pcieport 0000:02:04.0: bridge window [io 0x1000-0x0fff] to [bus
07-2c] add_size 1000
[ 134.792222] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792224] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792227] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792229] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792234] pci 0000:07:00.0: BAR 0: no space for [mem size 0x00010000]
[ 134.792236] pci 0000:07:00.0: BAR 0: failed to assign [mem size 0x00010000]
[ 134.792239] pcieport 0000:02:04.0: PCI bridge to [bus 07-2c]
[ 134.792249] pcieport 0000:02:04.0: bridge window [mem
0x54000000-0x5fdfffff]
[ 134.792256] pcieport 0000:02:04.0: bridge window [mem
0x6000000000-0x601bffffff 64bit pref]
[ 134.792266] PCI: No. 2 try to assign unassigned res
[ 134.792269] pcieport 0000:02:04.0: resource 14 [mem 0x54000000-0x5fdfffff]
released
[ 134.792271] pcieport 0000:02:04.0: PCI bridge to [bus 07-2c]
[ 134.792278] pcieport 0000:02:04.0: bridge window [io 0x1000-0x0fff] to [bus
07-2c] add_size 1000
[ 134.792284] pcieport 0000:02:04.0: BAR 14: no space for [mem size
0x0be00000]
[ 134.792286] pcieport 0000:02:04.0: BAR 14: failed to assign [mem size
0x0be00000]
[ 134.792289] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792290] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792294] pcieport 0000:02:04.0: BAR 14: no space for [mem size
0x0be00000]
[ 134.792295] pcieport 0000:02:04.0: BAR 14: failed to assign [mem size
0x0be00000]
[ 134.792298] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792299] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792302] pci 0000:07:00.0: BAR 0: no space for [mem size 0x00010000]
[ 134.792303] pci 0000:07:00.0: BAR 0: failed to assign [mem size 0x00010000]
[ 134.792305] pcieport 0000:02:04.0: PCI bridge to [bus 07-2c]
[ 134.792318] pcieport 0000:02:04.0: bridge window [mem
0x6000000000-0x601bffffff 64bit pref]
[ 134.793120] xhci_hcd 0000:07:00.0: init 0000:07:00.0 fail, -16
[ 134.793131] xhci_hcd: probe of 0000:07:00.0 failed with error -16
[ 279.153557] audit: type=1101 audit(1582476267.943:111): pid=2448
--
You are receiving this mail because:
You are watching the assignee of the bug.
next prev parent reply other threads:[~2020-02-23 22:32 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-02-23 22:14 [Bug 206649] New: Lenovo C940 - USB3 disk not detected if connected after boot bugzilla-daemon
2020-02-23 22:15 ` [Bug 206649] " bugzilla-daemon
2020-02-23 22:32 ` bugzilla-daemon [this message]
2020-02-23 22:33 ` [Bug 206649] Lenovo C940 - USB3 disk not detected if connected after boot - no space for [mem size 0x00010000] bugzilla-daemon
2020-02-26 22:10 ` bugzilla-daemon
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=bug-206649-208809-IO0eX4818h@https.bugzilla.kernel.org/ \
--to=bugzilla-daemon@bugzilla.kernel.org \
--cc=linux-usb@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).