[Bug 219824] [6.13 regression] USB controller just died

[bugzilla-daemon@kernel.org]

https://bugzilla.kernel.org/show_bug.cgi?id=219824

--- Comment #4 from Artem S. Tashkinov (aros@gmx.com) ---
This just happened again:

[161470.836493] PM: resume devices took 0.547 seconds
[161470.836720] OOM killer enabled.
[161470.836721] Restarting tasks ... done.
[161470.839715] random: crng reseeded on system resumption
[161470.845090] PM: suspend exit
[161471.322491] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: DSP1: Firmware: 400a4
vendor: 0x2 v0.43.1, 2 algorithms
[161471.324469] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: DSP1:
cirrus/cs35l41-dsp1-spk-prot-103c8b72.bin: v0.43.1
[161471.324480] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: DSP1: spk-prot:
D:\Amp Tuning\HP\840\0930\103C8B45_220930.bin
[161471.403951] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.1: Calibration applied:
R0=10446
[161471.407392] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: Calibration applied:
R0=10526
[161471.432157] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.1: Firmware Loaded -
Type: spk-prot, Gain: 17
[161471.433916] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: Firmware Loaded -
Type: spk-prot, Gain: 17
[161471.523827] hp_wmi: Unknown event_id - 131073 - 0x0
[162644.637587] xhci_hcd 0000:c3:00.3: xHCI host not responding to stop
endpoint command
[162644.651068] xhci_hcd 0000:c3:00.3: xHCI host controller not responding,
assume dead
[162644.651076] xhci_hcd 0000:c3:00.3: HC died; cleaning up
[162644.651099] xhci_hcd 0000:c3:00.3: Timeout while waiting for stop endpoint
command
[162644.651102] usb 1-2: USB disconnect, device number 4
[162644.678374] usb 1-3: USB disconnect, device number 2
[162644.678748] usb 1-4: USB disconnect, device number 3

Shortly after resume all the USB ports are disabled.

I'm reverting back to Linux 6.11. I cannot use my device like this.

-- 
You may reply to this email to add a comment.

You are receiving this mail because:
You are watching the assignee of the bug.