[Bug 220181] Users across distributions see “config failed, hub doesn’t have any ports! (err -19)” from xhci_hcd at boot.

[bugzilla-daemon@kernel.org]

https://bugzilla.kernel.org/show_bug.cgi?id=220181

Simorgh P. (ali@pourdanandeh.com) changed:

           What    |Removed                     |Added
----------------------------------------------------------------------------
                 CC|                            |ali@pourdanandeh.com

--- Comment #17 from Simorgh P. (ali@pourdanandeh.com) ---
Hi all.

My first time posting on kernel.org

I am on openSUSE Slowroll with 6.16.7-1.0.8.sr20250901-default kernel.
I used to be on openSUSE Leap since 2016, but could not get it to run on my new
machine, hence moving on to Slowroll. I am not tech savvy as most of you
though.

Machine:
AMD Ryzen 7 7800X3D (16) @ 5.05 GHz
AMD Radeon RX 9070/9070 XT/9070 driver: amdgpu v: kernel
ASUSTeK TUF GAMING B650-PLUS WIFI v: 3281 (latest Bios firmware)


Upon boot I get:
hub 8-0:1.0: config failed, hub doesn't have any ports! (err -19)

The USB port 8 is
readlink /sys/bus/usb/devices/usb8
../../../devices/pci0000:00/0000:00:08.3/0000:0f:00.0/usb8

And it is only USB 2.0
lspci -s 0f:00.0
0f:00.0 USB controller: Advanced Micro Devices, Inc. [AMD] Raphael/Granite
Ridge USB 2.0 xHCI

sudo cat /sys/kernel/debug/usb/xhci/0000:0f:00.0/reg-ext-protocol:00
EXTCAP_REVISION = 0x02000402
EXTCAP_NAME = 0x20425355
EXTCAP_PORTINFO = 0x00180101
EXTCAP_PORTTYPE = 0x00000000


There are two reasons I am posting here:
1. To (maybe) contribute another case that faces the same error.
2. How to go about and do something about it without breaking anything.

Do I apply the patch on my current kernel?

Would appreciate your guidance.

Regards.

-- 
You may reply to this email to add a comment.

You are receiving this mail because:
You are watching the assignee of the bug.