From: Ezequiel Garcia <ezequiel.garcia@free-electrons.com>
To: Guenter Roeck <linux@roeck-us.net>
Cc: linux-arm-kernel@lists.infradead.org,
linux-watchdog@vger.kernel.org, devicetree@vger.kernel.org,
Wim Van Sebroeck <wim@iguana.be>,
Gregory Clement <gregory.clement@free-electrons.com>,
Lior Amsalem <alior@marvell.com>,
Tawfik Bayouk <tawfik@marvell.com>,
Thomas Petazzoni <thomas.petazzoni@free-electrons.com>,
Jason Cooper <jason@lakedaemon.net>,
Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>,
Jason Gunthorpe <jgunthorpe@obsidianresearch.com>,
Andrew Lunn <andrew@lunn.ch>,
Daniel Lezcano <daniel.lezcano@linaro.org>,
Fabio Estevam <festevam@gmail.com>
Subject: Re: [PATCH v3 08/15] watchdog: orion: Introduce per-compatible of_device_id data
Date: Wed, 22 Jan 2014 14:06:22 -0300 [thread overview]
Message-ID: <20140122170621.GC27273@localhost> (raw)
In-Reply-To: <20140121163547.GB3311@roeck-us.net>
On Tue, Jan 21, 2014 at 08:35:47AM -0800, Guenter Roeck wrote:
> On Tue, Jan 21, 2014 at 10:26:07AM -0300, Ezequiel Garcia wrote:
> > This commit adds an orion_watchdog_data structure to holda compatible-data
>
> s/holda/hold/
>
Yup.
> > information. This allows to remove the driver-wide definition and to
> > future add support for multiple compatible-strings.
>
> Maybe "and to be able to add support for multiple compatible-strings in the
> future" ?
>
Yes, sounds better.
[..]
> >
> > #define WDT_MAX_CYCLE_COUNT 0xffffffff
> > #define WDT_IN_USE 0
> > #define WDT_OK_TO_CLOSE 1
> >
> While looking at the new defines below, I noticed that WDT_IN_USE and
> WDT_OK_TO_CLOSE are not used (anymore ?) and thus should be removed
> (separate patch, though).
>
OK, let's clean this.
> > -#define WDT_RESET_OUT_EN BIT(1)
> > +#define WDT_A370_RATIO_MASK(v) ((v) << 16)
> > +#define WDT_A370_RATIO_SHIFT 5
> > +#define WDT_A370_RATIO (1 << WDT_A370_RATIO_SHIFT)
> > +
> > +#define WDT_AXP_FIXED_ENABLE_BIT BIT(10)
> >
> Those new defines are not used. They should be introduced if and when used.
>
Hm... maybe after dozens and dozens of rebases these macros sneaked here?
[..]
> >
> > + match = of_match_device(orion_wdt_of_match_table, &pdev->dev);
> > + if (!match)
> > + /* Default legacy match */
> > + match = &orion_wdt_of_match_table[0];
> > +
> > dev->wdt.info = &orion_wdt_info;
> > dev->wdt.ops = &orion_wdt_ops;
> > dev->wdt.min_timeout = 1;
> > + dev->data = (struct orion_watchdog_data *)match->data;
>
> match->data is a void *, so the typecast should not be needed here.
> You might want to declare 'data' to be of type
> 'const struct orion_watchdog_data *' because otherwise you loose the
> 'const' attribute of match->data (which may be the reason for the typecast ?).
>
Done.
Thanks a lot for reviewing!
--
Ezequiel García, Free Electrons
Embedded Linux, Kernel and Android Engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe linux-watchdog" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2014-01-22 17:06 UTC|newest]
Thread overview: 24+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-01-21 13:25 [PATCH v3 00/15] Armada 370/XP watchdog support Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 01/15] ARM: Introduce atomic MMIO modify Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 02/15] clocksource: orion: Use atomic access for shared registers Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 03/15] watchdog: " Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 04/15] watchdog: orion: Handle IRQ Ezequiel Garcia
2014-01-21 14:31 ` Guenter Roeck
2014-01-21 14:35 ` Ezequiel Garcia
2014-01-27 6:30 ` Ezequiel Garcia
2014-01-27 6:42 ` Guenter Roeck
2014-01-27 7:18 ` Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 05/15] watchdog: orion: Make RSTOUT register a separate resource Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 06/15] watchdog: orion: Remove unneeded BRIDGE_CAUSE clear Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 07/15] watchdog: orion: Introduce an orion_watchdog device structure Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 08/15] watchdog: orion: Introduce per-compatible of_device_id data Ezequiel Garcia
2014-01-21 16:35 ` Guenter Roeck
2014-01-22 17:06 ` Ezequiel Garcia [this message]
2014-01-21 13:26 ` [PATCH v3 09/15] watchdog: orion: Add per-compatible clock initialization Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 10/15] watchdog: orion: Add per-compatible watchdog start implementation Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 11/15] watchdog: orion: Add support for Armada 370 and Armada XP SoC Ezequiel Garcia
2014-01-21 16:41 ` Guenter Roeck
2014-01-21 13:26 ` [PATCH v3 12/15] ARM: mvebu: Enable Armada 370/XP watchdog in the devicetree Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 13/15] ARM: kirkwood: Add RSTOUT 'reg' entry to devicetree Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 14/15] watchdog: orion: Enable the build on ARCH_MVEBU Ezequiel Garcia
2014-01-21 13:26 ` [PATCH v3 15/15] ARM: mvebu: Enable watchdog support in defconfig Ezequiel Garcia
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20140122170621.GC27273@localhost \
--to=ezequiel.garcia@free-electrons.com \
--cc=alior@marvell.com \
--cc=andrew@lunn.ch \
--cc=daniel.lezcano@linaro.org \
--cc=devicetree@vger.kernel.org \
--cc=festevam@gmail.com \
--cc=gregory.clement@free-electrons.com \
--cc=jason@lakedaemon.net \
--cc=jgunthorpe@obsidianresearch.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-watchdog@vger.kernel.org \
--cc=linux@roeck-us.net \
--cc=sebastian.hesselbarth@gmail.com \
--cc=tawfik@marvell.com \
--cc=thomas.petazzoni@free-electrons.com \
--cc=wim@iguana.be \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).