Re: [PATCH RESEND v6 0/2] watchdog: Add support for ImgTec PowerDown Controller Watchdog Timer

[Ezequiel Garcia <ezequiel.garcia@imgtec.com>]

Wim,

On 11/27/2014 01:54 AM, Naidu Tellapati wrote:
> This patchset provides support for the PowerDown Controller (PDC) Watchdog Timer
> found on Pistachio SOC from Imagination Technologies (ImgTec).
> 
> The series is based on 3.18-rc5.
> 
> I am re-sending the series with correct Signed-off-by headers.
> 
> Changes from v5:
> 
>  * Removed unused struct pdc_wdt_dev variables.
> 
>  * Removed out_wdt label in probe function.
> 
> Changes from v4:
> 
>  * Added warning message if initial timeout value exceeds maximum timeout.
> 
> Changes from v3:
> 
>  * Removed PDC_WD_MAX_DELAY.
> 
>  * Removed spinlock.
> 
>  * Removed timeout check inside pdc_wdt_set_timeout function.
> 
>  * Changed identity to IMG PDC Watchdog.
> 
>  * Removed pdc_wdt_set_timeout call from the probe function.
> 
>  * Removed pdc_wdt_shutdown function call from pdc_wdt_remove function
>    and added pdc_wdt_stop function call instead.
> 
> Changes from v2:
> 
>  * Removed interrupt.h header file.
> 
>  * Removed clock rate-change notifier callback.
> 
> Changes from v1:
> 
>  * Arranged all include files in alphabetical order.
> 
>  * Arranged register field masks/shifts defines next to their
>    corresponding register
> 
>  * Registered clock rate-change notifier callback.
> 
>  * Removed all references to 32 kHz fixed clock rate.
>    Now the clock rate is read dynamically using clk_get_rate().
> 
>  * Defined a macro PDC_WD_CONFIG_ENABLE.
> 
>  * Added code for getting system clock.
> 
>  * Moved module_param stuffs next to the corresponding variable defines.
> 
>  * Added code in the function pdc_wdt_remove for stopping watchdog.
> 
>  * Removed MODULE_ALIAS.
> 
>  * Removed few unwanted spaces and unwanted blank lines.
> 
> Naidu Tellapati (2):
>   watchdog: ImgTec PDC Watchdog Timer Driver
>   DT: watchdog: Add ImgTec PDC Watchdog Timer binding documentation
> 

Do you think it's possible to merge this series in time for v3.19?

Thanks!
-- 
Ezequiel