Re: [PATCH 08/17] watchdog: qcom: configure BARK time in addition to BITE time

[Guenter Roeck <linux@roeck-us.net>]

On 03/23/2016 03:05 PM, Matthew McClintock wrote:
> For certain parts and some versions of TZ, TZ will reset the chip
> when a BARK is triggered even though it was not configured here. So
> by default let's configure this BARK time as well.
>
> Signed-off-by: Matthew McClintock <mmcclint@codeaurora.org>

Reviewed-by: Guenter Roeck <linux@roeck-us.net>

> ---
>   drivers/watchdog/qcom-wdt.c | 5 +++++
>   1 file changed, 5 insertions(+)
>
> diff --git a/drivers/watchdog/qcom-wdt.c b/drivers/watchdog/qcom-wdt.c
> index e46f18d..53f57c3 100644
> --- a/drivers/watchdog/qcom-wdt.c
> +++ b/drivers/watchdog/qcom-wdt.c
> @@ -22,18 +22,21 @@
>   enum wdt_reg {
>   	WDT_RST,
>   	WDT_EN,
> +	WDT_BARK_TIME,
>   	WDT_BITE_TIME,
>   };
>
>   static const u32 reg_offset_data_apcs_tmr[] = {
>   	[WDT_RST] = 0x38,
>   	[WDT_EN] = 0x40,
> +	[WDT_BARK_TIME] = 0x4C,
>   	[WDT_BITE_TIME] = 0x5C,
>   };
>
>   static const u32 reg_offset_data_kpss[] = {
>   	[WDT_RST] = 0x4,
>   	[WDT_EN] = 0x8,
> +	[WDT_BARK_TIME] = 0x10,
>   	[WDT_BITE_TIME] = 0x14,
>   };
>
> @@ -62,6 +65,7 @@ static int qcom_wdt_start(struct watchdog_device *wdd)
>
>   	writel(0, wdt_addr(wdt, WDT_EN));
>   	writel(1, wdt_addr(wdt, WDT_RST));
> +	writel(wdd->timeout * wdt->rate, wdt_addr(wdt, WDT_BARK_TIME));
>   	writel(wdd->timeout * wdt->rate, wdt_addr(wdt, WDT_BITE_TIME));
>   	writel(1, wdt_addr(wdt, WDT_EN));
>   	return 0;
> @@ -104,6 +108,7 @@ static int qcom_wdt_restart(struct watchdog_device *wdd, unsigned long action,
>
>   	writel(0, wdt_addr(wdt, WDT_EN));
>   	writel(1, wdt_addr(wdt, WDT_RST));
> +	writel(timeout, wdt_addr(wdt, WDT_BARK_TIME));
>   	writel(timeout, wdt_addr(wdt, WDT_BITE_TIME));
>   	writel(1, wdt_addr(wdt, WDT_EN));
>
>