From: Felix Fietkau <nbd@openwrt.org>
To: linux-wireless@vger.kernel.org
Cc: linville@tuxdriver.com, lrodriguez@atheros.com
Subject: [PATCH 3/3] ath9k: use the key handling code from ath9k_common instead of duplicating it
Date: Tue, 25 May 2010 19:42:46 +0200 [thread overview]
Message-ID: <1274809366-73422-3-git-send-email-nbd@openwrt.org> (raw)
In-Reply-To: <1274809366-73422-2-git-send-email-nbd@openwrt.org>
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
---
drivers/net/wireless/ath/ath9k/main.c | 232 +--------------------------------
1 files changed, 2 insertions(+), 230 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index abfa049..135eb4c 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -615,234 +615,6 @@ static u32 ath_get_extchanmode(struct ath_softc *sc,
return chanmode;
}
-static int ath_setkey_tkip(struct ath_common *common, u16 keyix, const u8 *key,
- struct ath9k_keyval *hk, const u8 *addr,
- bool authenticator)
-{
- struct ath_hw *ah = common->ah;
- const u8 *key_rxmic;
- const u8 *key_txmic;
-
- key_txmic = key + NL80211_TKIP_DATA_OFFSET_TX_MIC_KEY;
- key_rxmic = key + NL80211_TKIP_DATA_OFFSET_RX_MIC_KEY;
-
- if (addr == NULL) {
- /*
- * Group key installation - only two key cache entries are used
- * regardless of splitmic capability since group key is only
- * used either for TX or RX.
- */
- if (authenticator) {
- memcpy(hk->kv_mic, key_txmic, sizeof(hk->kv_mic));
- memcpy(hk->kv_txmic, key_txmic, sizeof(hk->kv_mic));
- } else {
- memcpy(hk->kv_mic, key_rxmic, sizeof(hk->kv_mic));
- memcpy(hk->kv_txmic, key_rxmic, sizeof(hk->kv_mic));
- }
- return ath9k_hw_set_keycache_entry(ah, keyix, hk, addr);
- }
- if (!common->splitmic) {
- /* TX and RX keys share the same key cache entry. */
- memcpy(hk->kv_mic, key_rxmic, sizeof(hk->kv_mic));
- memcpy(hk->kv_txmic, key_txmic, sizeof(hk->kv_txmic));
- return ath9k_hw_set_keycache_entry(ah, keyix, hk, addr);
- }
-
- /* Separate key cache entries for TX and RX */
-
- /* TX key goes at first index, RX key at +32. */
- memcpy(hk->kv_mic, key_txmic, sizeof(hk->kv_mic));
- if (!ath9k_hw_set_keycache_entry(ah, keyix, hk, NULL)) {
- /* TX MIC entry failed. No need to proceed further */
- ath_print(common, ATH_DBG_FATAL,
- "Setting TX MIC Key Failed\n");
- return 0;
- }
-
- memcpy(hk->kv_mic, key_rxmic, sizeof(hk->kv_mic));
- /* XXX delete tx key on failure? */
- return ath9k_hw_set_keycache_entry(ah, keyix + 32, hk, addr);
-}
-
-static int ath_reserve_key_cache_slot_tkip(struct ath_common *common)
-{
- int i;
-
- for (i = IEEE80211_WEP_NKID; i < common->keymax / 2; i++) {
- if (test_bit(i, common->keymap) ||
- test_bit(i + 64, common->keymap))
- continue; /* At least one part of TKIP key allocated */
- if (common->splitmic &&
- (test_bit(i + 32, common->keymap) ||
- test_bit(i + 64 + 32, common->keymap)))
- continue; /* At least one part of TKIP key allocated */
-
- /* Found a free slot for a TKIP key */
- return i;
- }
- return -1;
-}
-
-static int ath_reserve_key_cache_slot(struct ath_common *common)
-{
- int i;
-
- /* First, try to find slots that would not be available for TKIP. */
- if (common->splitmic) {
- for (i = IEEE80211_WEP_NKID; i < common->keymax / 4; i++) {
- if (!test_bit(i, common->keymap) &&
- (test_bit(i + 32, common->keymap) ||
- test_bit(i + 64, common->keymap) ||
- test_bit(i + 64 + 32, common->keymap)))
- return i;
- if (!test_bit(i + 32, common->keymap) &&
- (test_bit(i, common->keymap) ||
- test_bit(i + 64, common->keymap) ||
- test_bit(i + 64 + 32, common->keymap)))
- return i + 32;
- if (!test_bit(i + 64, common->keymap) &&
- (test_bit(i , common->keymap) ||
- test_bit(i + 32, common->keymap) ||
- test_bit(i + 64 + 32, common->keymap)))
- return i + 64;
- if (!test_bit(i + 64 + 32, common->keymap) &&
- (test_bit(i, common->keymap) ||
- test_bit(i + 32, common->keymap) ||
- test_bit(i + 64, common->keymap)))
- return i + 64 + 32;
- }
- } else {
- for (i = IEEE80211_WEP_NKID; i < common->keymax / 2; i++) {
- if (!test_bit(i, common->keymap) &&
- test_bit(i + 64, common->keymap))
- return i;
- if (test_bit(i, common->keymap) &&
- !test_bit(i + 64, common->keymap))
- return i + 64;
- }
- }
-
- /* No partially used TKIP slots, pick any available slot */
- for (i = IEEE80211_WEP_NKID; i < common->keymax; i++) {
- /* Do not allow slots that could be needed for TKIP group keys
- * to be used. This limitation could be removed if we know that
- * TKIP will not be used. */
- if (i >= 64 && i < 64 + IEEE80211_WEP_NKID)
- continue;
- if (common->splitmic) {
- if (i >= 32 && i < 32 + IEEE80211_WEP_NKID)
- continue;
- if (i >= 64 + 32 && i < 64 + 32 + IEEE80211_WEP_NKID)
- continue;
- }
-
- if (!test_bit(i, common->keymap))
- return i; /* Found a free slot for a key */
- }
-
- /* No free slot found */
- return -1;
-}
-
-static int ath_key_config(struct ath_common *common,
- struct ieee80211_vif *vif,
- struct ieee80211_sta *sta,
- struct ieee80211_key_conf *key)
-{
- struct ath_hw *ah = common->ah;
- struct ath9k_keyval hk;
- const u8 *mac = NULL;
- int ret = 0;
- int idx;
-
- memset(&hk, 0, sizeof(hk));
-
- switch (key->alg) {
- case ALG_WEP:
- hk.kv_type = ATH9K_CIPHER_WEP;
- break;
- case ALG_TKIP:
- hk.kv_type = ATH9K_CIPHER_TKIP;
- break;
- case ALG_CCMP:
- hk.kv_type = ATH9K_CIPHER_AES_CCM;
- break;
- default:
- return -EOPNOTSUPP;
- }
-
- hk.kv_len = key->keylen;
- memcpy(hk.kv_val, key->key, key->keylen);
-
- if (!(key->flags & IEEE80211_KEY_FLAG_PAIRWISE)) {
- /* For now, use the default keys for broadcast keys. This may
- * need to change with virtual interfaces. */
- idx = key->keyidx;
- } else if (key->keyidx) {
- if (WARN_ON(!sta))
- return -EOPNOTSUPP;
- mac = sta->addr;
-
- if (vif->type != NL80211_IFTYPE_AP) {
- /* Only keyidx 0 should be used with unicast key, but
- * allow this for client mode for now. */
- idx = key->keyidx;
- } else
- return -EIO;
- } else {
- if (WARN_ON(!sta))
- return -EOPNOTSUPP;
- mac = sta->addr;
-
- if (key->alg == ALG_TKIP)
- idx = ath_reserve_key_cache_slot_tkip(common);
- else
- idx = ath_reserve_key_cache_slot(common);
- if (idx < 0)
- return -ENOSPC; /* no free key cache entries */
- }
-
- if (key->alg == ALG_TKIP)
- ret = ath_setkey_tkip(common, idx, key->key, &hk, mac,
- vif->type == NL80211_IFTYPE_AP);
- else
- ret = ath9k_hw_set_keycache_entry(ah, idx, &hk, mac);
-
- if (!ret)
- return -EIO;
-
- set_bit(idx, common->keymap);
- if (key->alg == ALG_TKIP) {
- set_bit(idx + 64, common->keymap);
- if (common->splitmic) {
- set_bit(idx + 32, common->keymap);
- set_bit(idx + 64 + 32, common->keymap);
- }
- }
-
- return idx;
-}
-
-static void ath_key_delete(struct ath_common *common, struct ieee80211_key_conf *key)
-{
- struct ath_hw *ah = common->ah;
-
- ath9k_hw_keyreset(ah, key->hw_key_idx);
- if (key->hw_key_idx < IEEE80211_WEP_NKID)
- return;
-
- clear_bit(key->hw_key_idx, common->keymap);
- if (key->alg != ALG_TKIP)
- return;
-
- clear_bit(key->hw_key_idx + 64, common->keymap);
- if (common->splitmic) {
- ath9k_hw_keyreset(ah, key->hw_key_idx + 32);
- clear_bit(key->hw_key_idx + 32, common->keymap);
- clear_bit(key->hw_key_idx + 64 + 32, common->keymap);
- }
-}
-
static void ath9k_bss_assoc_info(struct ath_softc *sc,
struct ieee80211_vif *vif,
struct ieee80211_bss_conf *bss_conf)
@@ -1804,7 +1576,7 @@ static int ath9k_set_key(struct ieee80211_hw *hw,
switch (cmd) {
case SET_KEY:
- ret = ath_key_config(common, vif, sta, key);
+ ret = ath9k_cmn_key_config(common, vif, sta, key);
if (ret >= 0) {
key->hw_key_idx = ret;
/* push IV and Michael MIC generation to stack */
@@ -1817,7 +1589,7 @@ static int ath9k_set_key(struct ieee80211_hw *hw,
}
break;
case DISABLE_KEY:
- ath_key_delete(common, key);
+ ath9k_cmn_key_delete(common, key);
break;
default:
ret = -EINVAL;
--
1.6.4.2
prev parent reply other threads:[~2010-05-25 17:42 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-05-25 17:42 [PATCH 1/3] ath9k_hw: add multicast key search support Felix Fietkau
2010-05-25 17:42 ` [PATCH 2/3] ath9k_common: use allocated key cache entries for multi BSS crypto support Felix Fietkau
2010-05-25 17:42 ` Felix Fietkau [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1274809366-73422-3-git-send-email-nbd@openwrt.org \
--to=nbd@openwrt.org \
--cc=linux-wireless@vger.kernel.org \
--cc=linville@tuxdriver.com \
--cc=lrodriguez@atheros.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox