[PATCH wireless-2.6.38] iwlwifi: fix valid chain reading from EEPROM

[Wey-Yi Guy <wey-yi.w.guy@intel.com>]

When read valid tx/rx chains from EEPROM, there is a bug to use the
tx chain value for both tx and rx, the result of this cause low
receive throughput on 1x2 devices becuase rx will only utilize single
chain instead of two chains

Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
---
this patch is also available from wireless-2.6 branch on
 git://git.kernel.org/pub/scm/linux/kernel/git/iwlwifi/iwlwifi-2.6.git
---
 drivers/net/wireless/iwlwifi/iwl-agn-eeprom.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/net/wireless/iwlwifi/iwl-agn-eeprom.c b/drivers/net/wireless/iwlwifi/iwl-agn-eeprom.c
index 97906dd..14ceb4d 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn-eeprom.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn-eeprom.c
@@ -168,7 +168,7 @@ int iwl_eeprom_check_sku(struct iwl_priv *priv)
 		/* not using .cfg overwrite */
 		radio_cfg = iwl_eeprom_query16(priv, EEPROM_RADIO_CONFIG);
 		priv->cfg->valid_tx_ant = EEPROM_RF_CFG_TX_ANT_MSK(radio_cfg);
-		priv->cfg->valid_rx_ant = EEPROM_RF_CFG_TX_ANT_MSK(radio_cfg);
+		priv->cfg->valid_rx_ant = EEPROM_RF_CFG_RX_ANT_MSK(radio_cfg);
 		if (!priv->cfg->valid_tx_ant || !priv->cfg->valid_rx_ant) {
 			IWL_ERR(priv, "Invalid chain (0X%x, 0X%x)\n",
 				priv->cfg->valid_tx_ant,
-- 
1.7.0.4