[PATCH 04/13] open80211s: Stop using zero for address 3 in mesh plink mgmt frames

[Javier Cardona <javier@cozybit.com>]

Previous versions of 11s draft used the all zeroes address.  Current
draft uses the same address as address 2.

Also, use the ANA-approved action category code for peer establishment frames.

Note: This breaks compatibility with previous mesh protocol instances.

Signed-off-by: Javier Cardona <javier@cozybit.com>
---
 net/mac80211/mesh_plink.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/net/mac80211/mesh_plink.c b/net/mac80211/mesh_plink.c
index 0120e9e..2c37bee 100644
--- a/net/mac80211/mesh_plink.c
+++ b/net/mac80211/mesh_plink.c
@@ -43,7 +43,7 @@
 #define dot11MeshMaxPeerLinks(s) (s->u.mesh.mshcfg.dot11MeshMaxPeerLinks)
 
 enum plink_frame_type {
-	PLINK_OPEN = 0,
+	PLINK_OPEN = 1,
 	PLINK_CONFIRM,
 	PLINK_CLOSE
 };
@@ -181,7 +181,7 @@ static int mesh_plink_frame_tx(struct ieee80211_sub_if_data *sdata,
 					  IEEE80211_STYPE_ACTION);
 	memcpy(mgmt->da, da, ETH_ALEN);
 	memcpy(mgmt->sa, sdata->vif.addr, ETH_ALEN);
-	/* BSSID is left zeroed, wildcard value */
+	memcpy(mgmt->bssid, sdata->vif.addr, ETH_ALEN);
 	mgmt->u.action.category = WLAN_CATEGORY_MESH_ACTION;
 	mgmt->u.action.u.plink_action.action_code = action;
 
-- 
1.7.1