[PATCH RESEND 3/4] mwifiex: enable SDIO multiport aggregation

[Bing Zhao <bzhao@marvell.com>]

From: Amitkumar Karwar <akarwar@marvell.com>

By default SDIO multiport aggregation is disabled. It's useful to
get good throughput results. This patch enables it.

Signed-off-by: Amitkumar Karwar <akarwar@marvell.com>
Signed-off-by: Bing Zhao <bzhao@marvell.com>
---
 drivers/net/wireless/mwifiex/sdio.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/mwifiex/sdio.c b/drivers/net/wireless/mwifiex/sdio.c
index 283171b..ffaf3f3 100644
--- a/drivers/net/wireless/mwifiex/sdio.c
+++ b/drivers/net/wireless/mwifiex/sdio.c
@@ -1630,14 +1630,14 @@ static int mwifiex_init_sdio(struct mwifiex_adapter *adapter)
 	card->mpa_tx.pkt_cnt = 0;
 	card->mpa_tx.start_port = 0;
 
-	card->mpa_tx.enabled = 0;
+	card->mpa_tx.enabled = 1;
 	card->mpa_tx.pkt_aggr_limit = SDIO_MP_AGGR_DEF_PKT_LIMIT;
 
 	card->mpa_rx.buf_len = 0;
 	card->mpa_rx.pkt_cnt = 0;
 	card->mpa_rx.start_port = 0;
 
-	card->mpa_rx.enabled = 0;
+	card->mpa_rx.enabled = 1;
 	card->mpa_rx.pkt_aggr_limit = SDIO_MP_AGGR_DEF_PKT_LIMIT;
 
 	/* Allocate buffers for SDIO MP-A */
-- 
1.7.0.2