USB Setup failed (-32)

["benjmeier@bluewin.ch" <benjmeier@bluewin.ch>]

Hello,

I have a Olimex SAM9-L9260-Board (http://www.olimex.com/dev/sam9-L9260.html), which has an ARM-Processor.

I used many 
devices on this hardware, mostly over usb (UMTS-Modems, Sticks...). Everything worked.
I saw that i can use the 
ar9170usb-driver for wireless, so i bought a Netgear WN111v2 (http://linuxwireless.org/en/users/Drivers/ar9170).

Then 
i installed the needed firmware. But it didnt work. This is the output:

usb 1-1.3: new full speed USB device using 
at91_ohci and address 3
usb 1-1.3: New USB device found, idVendor=0846, idProduct=9001
usb 1-1.3: New USB device 
strings: Mfr=16, Product=32, SerialNumber=48
usb 1-1.3: Product: USB2.0 WLAN
usb 1-1.3: Manufacturer: ATHER
usb 1-1.3: 
SerialNumber: 12345
cfg80211: Calling CRDA to update world regulatory domain
usb 1-1.3: reset full speed USB device 
using at91_ohci and address 3
usbcore: registered new interface driver ar9170usb
usb 1-1.3: firmware: requesting ar9170.
fw
usb 1-1.3: USB setup failed (-32).

I searched everywhere the errormessage with the errorcode -32, but i didnt find 
a meaning.
On the pc the wireless-stick works perfectly (with the same firmware).

Has someone an idea what i can do?


Thanks
Best Regards