From: Wey-Yi Guy <wey-yi.w.guy@intel.com>
To: linville@tuxdriver.com
Cc: linux-wireless@vger.kernel.org,
Emmanuel Grumbach <emmanuel.grumbach@intel.com>,
Wey-Yi Guy <wey-yi.w.guy@intel.com>
Subject: [PATCH 15/28] iwlwifi: move the RF kill logic from iwl_probe to transport
Date: Thu, 2 Feb 2012 15:09:06 -0800 [thread overview]
Message-ID: <1328224159-18134-16-git-send-email-wey-yi.w.guy@intel.com> (raw)
In-Reply-To: <1328224159-18134-1-git-send-email-wey-yi.w.guy@intel.com>
From: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
This is another clean up of the proble flow.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
---
drivers/net/wireless/iwlwifi/iwl-agn.c | 23 -----------------------
drivers/net/wireless/iwlwifi/iwl-trans-pcie.c | 11 +++++++++++
2 files changed, 11 insertions(+), 23 deletions(-)
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn.c b/drivers/net/wireless/iwlwifi/iwl-agn.c
index 8846246..14f8b75 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn.c
@@ -1815,13 +1815,6 @@ int iwl_probe(struct iwl_bus *bus, const struct iwl_trans_ops *trans_ops,
spin_lock_init(&trans(priv)->reg_lock);
spin_lock_init(&priv->shrd->lock);
- /*
- * stop and reset the on-board processor just in case it is in a
- * strange state ... like being left stranded by a primary kernel
- * and this is now the kdump kernel trying to start up
- */
- iwl_write32(trans(priv), CSR_RESET, CSR_RESET_REG_FLAG_NEVO_RESET);
-
/***********************
* 3. Read REV register
***********************/
@@ -1890,22 +1883,6 @@ int iwl_probe(struct iwl_bus *bus, const struct iwl_trans_ops *trans_ops,
iwl_setup_rx_handlers(priv);
iwl_testmode_init(priv);
- /*********************************************
- * 8. Enable interrupts
- *********************************************/
-
- iwl_enable_rfkill_int(priv);
-
- /* If platform's RF_KILL switch is NOT set to KILL */
- if (iwl_read32(trans(priv),
- CSR_GP_CNTRL) & CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW)
- clear_bit(STATUS_RF_KILL_HW, &priv->shrd->status);
- else
- set_bit(STATUS_RF_KILL_HW, &priv->shrd->status);
-
- wiphy_rfkill_set_hw_state(priv->hw->wiphy,
- test_bit(STATUS_RF_KILL_HW, &priv->shrd->status));
-
iwl_power_initialize(priv);
iwl_tt_initialize(priv);
diff --git a/drivers/net/wireless/iwlwifi/iwl-trans-pcie.c b/drivers/net/wireless/iwlwifi/iwl-trans-pcie.c
index 43e894f..362444a 100644
--- a/drivers/net/wireless/iwlwifi/iwl-trans-pcie.c
+++ b/drivers/net/wireless/iwlwifi/iwl-trans-pcie.c
@@ -1393,6 +1393,17 @@ static int iwl_trans_pcie_start_hw(struct iwl_trans *trans)
iwl_apm_init(trans);
+ /* If platform's RF_KILL switch is NOT set to KILL */
+ if (iwl_read32(trans,
+ CSR_GP_CNTRL) & CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW)
+ clear_bit(STATUS_RF_KILL_HW, &trans->shrd->status);
+ else
+ set_bit(STATUS_RF_KILL_HW, &trans->shrd->status);
+
+ iwl_set_hw_rfkill_state(priv(trans),
+ test_bit(STATUS_RF_KILL_HW,
+ &trans->shrd->status));
+
return err;
error:
--
1.7.0.4
next prev parent reply other threads:[~2012-02-03 0:16 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-02-02 23:08 [PATCH 00/28] update for 3.4: iwlwifi 2012-02-02 Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 01/28] iwlwifi: add fw_alive to transport layer API, kill tx_start Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 02/28] iwlwifi: Connect IDI transport to driver Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 03/28] iwlwifi: separate the APM from the EEPROM Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 04/28] iwlwifi: move the shrd memory from priv Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 05/28] iwlwifi: allocate the transport from the bus layer Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 06/28] iwlwifi: move the bus configuration to transport Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 07/28] iwlwifi: the read / write register ops move " Wey-Yi Guy
2012-02-02 23:08 ` [PATCH 08/28] iwlwifi: give trans to all the read / write functions Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 09/28] iwlwifi: remove the pointer to dev from the bus layer Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 10/28] iwlwifi: don't use the bus for ucode fw_desc any more Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 11/28] iwlwifi: rename trans_ops->request_irq to trans_ops->start_hw Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 12/28] iwlwifi: move prepare_card_hw to start_hw Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 13/28] iwlwifi: move apm_init " Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 14/28] iwlwifi: introduce trans_ops->stop_hw Wey-Yi Guy
2012-02-02 23:09 ` Wey-Yi Guy [this message]
2012-02-02 23:09 ` [PATCH 16/28] iwlwifi: consolidate the start_device flow Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 17/28] iwlwifi: kill bus_apm_config Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 18/28] iwlwifi: kill bus_is_pm_supported Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 19/28] iwlwifi: kill bus_get_hw_id_string Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 20/28] iwlwifi: kill bus_get_hw_id Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 21/28] iwlwifi: move hw_rev to transport layer Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 22/28] iwlwifi: stop_hw replace enable_rfkill_int Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 23/28] iwlwifi: debug print in tx_queue_set_status is more clear Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 24/28] iwlwifi: clarify comment Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 25/28] iwlwifi: move bcast_sta_id init to common routine Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 26/28] iwlwifi: move all ucode routines to iwl-ucode.c Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 27/28] iwlwifi: release IRQ in error path Wey-Yi Guy
2012-02-02 23:09 ` [PATCH 28/28] iwlwifi: range check to testmode direct reg access Wey-Yi Guy
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1328224159-18134-16-git-send-email-wey-yi.w.guy@intel.com \
--to=wey-yi.w.guy@intel.com \
--cc=emmanuel.grumbach@intel.com \
--cc=linux-wireless@vger.kernel.org \
--cc=linville@tuxdriver.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).