[PATCH 05/10] wlcore: use correct link for bcast/multicast frames

[Arik Nemtsov <arik@wizery.com>]

From: Eliad Peller <eliad@wizery.com>

Multicast management frames (e.g. global deauth)
should be sent out on the bcast link, rather than
the global, which should be used only for pre-added
stations (e.g. for auth/assoc resp).

Signed-off-by: Eliad Peller <eliad@wizery.com>
Signed-off-by: Eyal Shapira <eyal@wizery.com>
Signed-off-by: Arik Nemtsov <arik@wizery.com>
---
 drivers/net/wireless/ti/wlcore/tx.c |    6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/wireless/ti/wlcore/tx.c b/drivers/net/wireless/ti/wlcore/tx.c
index 200d091..e8a2998 100644
--- a/drivers/net/wireless/ti/wlcore/tx.c
+++ b/drivers/net/wireless/ti/wlcore/tx.c
@@ -148,10 +148,10 @@ u8 wl12xx_tx_get_hlid_ap(struct wl1271 *wl, struct wl12xx_vif *wlvif,
 			return wl->system_hlid;
 
 		hdr = (struct ieee80211_hdr *)skb->data;
-		if (ieee80211_is_mgmt(hdr->frame_control))
-			return wlvif->ap.global_hlid;
-		else
+		if (is_multicast_ether_addr(ieee80211_get_DA(hdr)))
 			return wlvif->ap.bcast_hlid;
+		else
+			return wlvif->ap.global_hlid;
 	}
 }
 
-- 
1.7.9.5