Re: missing RX_FLAG_DECRIPTED in ieee80211_rx_status after first reassociation in 802.11R

[Johannes Berg <johannes@sipsolutions.net>]

On Tue, 2013-01-08 at 12:11 +0100, Cedric Debarge wrote:
> Hi all,
> 
> 	I dug a little more on this problem and I found that hardware encryption is disabled after the first roam because ieee80211_key_enable_hw_accel fails on the following test :
> 		if (sta && !sta->uploaded) 
> 			goto out_unsupported;
> 
> 	After the first roam, sta->uploaded is tested before sta_info_move_state sets it to true.
> 
> 	At the first association/authentication :
> 	1) sta_info_move_state sets sta->uploaded to true
> 	2) ieee80211_key_enable_hw_accel test it and find it true --> hardware decoding
> 
> 	When the station changes from an AP to another :
> 	1) ieee80211_key_enable_hw_accel test it and find it false --> software decoding
> 	2) sta_info_move_state sets sta->uploaded to true

I cannot reproduce this. Could you obtain tracing information
("trace-cmd record -e cfg80211") on an affected system?

Also a wpa_supplicant debug log would be helpful. Or better yet, use a
new supplicant with the "-T" parameter -- this will make its debug
information go into the cfg80211 tracing that you record as per above.

johannes