[PATCH 1/4] ARM: dts: omap4-panda: add MMC5 (WiLink WLAN) configuration

[Luciano Coelho <coelho@ti.com>]

Add regulator, pin muxing and MMC5 configuration to be used by the
on-board WiLink6 module.

Signed-off-by: Luciano Coelho <coelho@ti.com>
---
 arch/arm/boot/dts/omap4-panda-common.dtsi | 31 ++++++++++++++++++++++++++++++-
 1 file changed, 30 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/omap4-panda-common.dtsi b/arch/arm/boot/dts/omap4-panda-common.dtsi
index faa95b5..b3f6e1f 100644
--- a/arch/arm/boot/dts/omap4-panda-common.dtsi
+++ b/arch/arm/boot/dts/omap4-panda-common.dtsi
@@ -107,6 +107,16 @@
 	 */
 		clock-frequency = <19200000>;
 	};
+
+	wilink_wl_en: fixedregulator@1 {
+		compatible = "regulator-fixed";
+		regulator-name = "wilink_wl_en";
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <1800000>;
+		gpio = <&gpio2 11 0>; /* gpio line 43 */
+		startup-delay-us = <70000>;
+		enable-active-high;
+	};
 };
 
 &omap4_pmx_wkup {
@@ -132,6 +142,7 @@
 			&dss_hdmi_pins
 			&tpd12s015_pins
 			&hsusbb1_pins
+			&wilink_pins
 	>;
 
 	twl6030_pins: pinmux_twl6030_pins {
@@ -235,6 +246,19 @@
 			0x1c (PIN_OUTPUT | MUX_MODE3)	/* gpio_wk8 */
 		>;
 	};
+
+	wilink_pins: pinmux_wilink_pins {
+		pinctrl-single,pins = <
+			0x7a 0x103      /* gpio_53  INPUT | MODE3 */
+			0x66 0x3	/* gpio_43  OUTPUT | MODE3 */
+			0x148 0x118     /* clk	    INPUT PULLUP | MODE0 */
+			0x14a 0x118     /* cmd	    INPUT PULLUP | MODE0 */
+			0x14c 0x118     /* dat0	    INPUT PULLUP | MODE0 */
+			0x14e 0x118     /* dat1	    INPUT PULLUP | MODE0 */
+			0x150 0x118     /* dat2	    INPUT PULLUP | MODE0 */
+			0x152 0x118     /* dat3	    INPUT PULLUP | MODE0 */
+		>;
+	};
 };
 
 &i2c1 {
@@ -314,8 +338,13 @@
 };
 
 &mmc5 {
-	ti,non-removable;
+	status = "okay";
+	vmmc-supply = <&wilink_wl_en>;
 	bus-width = <4>;
+	cap-power-off-card;
+	keep-power-in-suspend;
+	ti,non-removable;
+	ti,needs-special-hs-handling;
 };
 
 &emif1 {
-- 
1.8.3.2