linux-wireless.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Emmanuel Grumbach <egrumbach@gmail.com>
To: linux-wireless@vger.kernel.org
Cc: Michal Nazarewicz <mina86@mina86.com>,
	Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Subject: [PATCH 19/29] iwlwifi: pcie: remove minor dead code
Date: Sun, 24 Nov 2013 22:06:36 +0200	[thread overview]
Message-ID: <1385323606-3603-19-git-send-email-egrumbach@gmail.com> (raw)
In-Reply-To: <52925BE7.4050406@gmail.com>

From: Michal Nazarewicz <mina86@mina86.com>

inta is checked to be zero in a IRQ_NONE branch so afterwards it
cannot be zero as it is never modified.

Signed-off-by: Michal Nazarewicz <mina86@mina86.com>
[reword the patch title and fix comment]
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
---
 drivers/net/wireless/iwlwifi/pcie/rx.c |   26 +++++++++++---------------
 1 file changed, 11 insertions(+), 15 deletions(-)

diff --git a/drivers/net/wireless/iwlwifi/pcie/rx.c b/drivers/net/wireless/iwlwifi/pcie/rx.c
index 3f237b4..79d46a9 100644
--- a/drivers/net/wireless/iwlwifi/pcie/rx.c
+++ b/drivers/net/wireless/iwlwifi/pcie/rx.c
@@ -1121,7 +1121,6 @@ static irqreturn_t iwl_pcie_isr(int irq, void *data)
 	struct iwl_trans *trans = data;
 	struct iwl_trans_pcie *trans_pcie = IWL_TRANS_GET_PCIE_TRANS(trans);
 	u32 inta, inta_mask;
-	irqreturn_t ret = IRQ_NONE;
 
 	lockdep_assert_held(&trans_pcie->irq_lock);
 
@@ -1150,7 +1149,16 @@ static irqreturn_t iwl_pcie_isr(int irq, void *data)
 	 * or due to sporadic interrupts thrown from our NIC. */
 	if (!inta) {
 		IWL_DEBUG_ISR(trans, "Ignore interrupt, inta == 0\n");
-		goto none;
+		/*
+		 * Re-enable interrupts here since we don't have anything to
+		 * service, but only in case the handler won't run. Note that
+		 * the handler can be scheduled because of a previous
+		 * interrupt.
+		 */
+		if (test_bit(STATUS_INT_ENABLED, &trans_pcie->status) &&
+		    !trans_pcie->inta)
+			iwl_enable_interrupts(trans);
+		return IRQ_NONE;
 	}
 
 	if ((inta == 0xFFFFFFFF) || ((inta & 0xFFFFFFF0) == 0xa5a5a5a0)) {
@@ -1168,19 +1176,7 @@ static irqreturn_t iwl_pcie_isr(int irq, void *data)
 
 	trans_pcie->inta |= inta;
 	/* the thread will service interrupts and re-enable them */
-	if (likely(inta))
-		return IRQ_WAKE_THREAD;
-
-	ret = IRQ_HANDLED;
-
-none:
-	/* re-enable interrupts here since we don't have anything to service. */
-	/* only Re-enable if disabled by irq  and no schedules tasklet. */
-	if (test_bit(STATUS_INT_ENABLED, &trans_pcie->status) &&
-	    !trans_pcie->inta)
-		iwl_enable_interrupts(trans);
-
-	return ret;
+	return IRQ_WAKE_THREAD;
 }
 
 /* interrupt handler using ict table, with this interrupt driver will
-- 
1.7.9.5


  parent reply	other threads:[~2013-11-24 20:07 UTC|newest]

Thread overview: 32+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2013-11-24 20:04 pull request: iwlwifi-next 2013_11_24 Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 01/29] iwlwifi: remove TX_CMD id from transport layer Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 02/29] iwlwifi: mvm: Add debugfs entry to generate NMI to NIC Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 03/29] iwlwifi: pcie: remove useless condition test Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 04/29] iwlwifi: mvm: fix and improve printing of rate scale table Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 05/29] iwlwifi: mvm: simplify iwl_mvm_send_lq_cmd Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 06/29] iwlwifi: mvm: refactor iwl_mvm_rs_rate_init Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 07/29] iwlwifi: mvm: enable d3_test even if d3_test_pme_ptr is not available Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 08/29] iwlwifi: mvm: disconnect on disconnection wakeup event Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 09/29] iwlwifi: mvm: implement rate_update hook in rs Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 10/29] iwlwifi: mvm: allow keeping connections in d3_test Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 11/29] iwlwifi: mvm: fix ht protection flags Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 12/29] iwlwifi: mvm: small debugfs cleanups Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 13/29] iwlwifi: mvm: move interface-specific debugfs to a new file Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 14/29] iwlwifi: mvm: don't use void pointers in debugfs Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 15/29] iwlwifi: mvm: refactor debugfs copy_from_user() Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 16/29] iwlwifi: mvm: add LQ flags definitions Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 17/29] iwlwifi: mvm: BT Coex - fine tune the aggregation size Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 18/29] iwlwifi: mvm: a few more SKUs for 7260 and 3160 Emmanuel Grumbach
2013-11-24 20:06 ` Emmanuel Grumbach [this message]
2013-11-24 20:06 ` [PATCH 20/29] iwlwifi: fix check for a single rx antenna Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 21/29] iwlwifi: mvm: add iwl_mvm_sta_from_mac80211 Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 22/29] iwlwifi: mvm: don't restart HW if suspending fails before D3 image is loaded Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 23/29] iwlwifi: mvm: dump NVM from debugfs Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 24/29] iwlwifi: mvm: fix scan offloading flag definition Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 25/29] iwlwifi: mvm: Implement low-priority scan Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 26/29] iwlwifi: mvm: quota command max_duration should be zero Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 27/29] iwlwifi: mvm: stop using MIMO in case BT doesn't allow it Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 28/29] iwlwifi: mvm: don't enable VHT MCS9 in 20Mhz Emmanuel Grumbach
2013-11-24 20:06 ` [PATCH 29/29] iwlwifi: mvm: don't configure mimo rates if nss is limited to 1 Emmanuel Grumbach
2013-12-02 18:40 ` pull request: iwlwifi-next 2013_11_24 John W. Linville
2013-12-02 19:23   ` John W. Linville

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1385323606-3603-19-git-send-email-egrumbach@gmail.com \
    --to=egrumbach@gmail.com \
    --cc=emmanuel.grumbach@intel.com \
    --cc=linux-wireless@vger.kernel.org \
    --cc=mina86@mina86.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).