Re: [alsa-devel] [ISSUE] rtl8192ce appears to interfere with ALSA playback

[Olivier Langlois <olivier@trillion01.com>]

Takashi,

On Thu, 2014-01-23 at 17:29 +0100, Takashi Iwai wrote:

> Which machine and codec?  For example, Lenovo IdeaPad with ALC269 is
> known to be broken with 48kHz, so we have a fixed rate limitation in
> the driver.
> 

it is a hpmini. I have this from dmesg:

[    9.638142] hda_codec: 92HD81B1X5: Apply fix-func for HP
[    9.639859] hda-codec: Enable HP auto-muting on NID 0xb
[    9.639888] hda-codec: Enable auto-mic switch on NID 0x11/0xa/0x0
[    9.642312] hda_codec: 92HD81B1X5: Apply fix-func for HP


> Other than the hardware restriction, you may play more with
> position_fix or bdl_pos_adj option of snd-hda-intel driver.
> 
thank you for the advice. I'll take a look on these params to see what
they do. However, because my sound card works very well all the time
except that I have underruns that happens only when wpa_supplicant is
doing this:

wlan0: Control interface command 'STATUS'
wlan0: State: DISCONNECTED -> SCANNING
...
wlan0: No suitable network found
wlan0: Setting scan request: 5 sec 0 usec
wlan0: Checking for other virtual interfaces sharing same radio (phy0)
in event_scan_results
wlan0: Starting AP scan for wildcard SSID
WPS: Building WPS IE for Probe Request
WPS:  * Version (hardcoded 0x10)
WPS:  * Request Type
WPS:  * Config Methods (148)
WPS:  * UUID-E
WPS:  * Primary Device Type
WPS:  * RF Bands (1)
WPS:  * Association State
WPS:  * Configuration Error (0)
WPS:  * Device Password ID (0)
WPS:  * Device Name
P2P: * P2P IE header
P2P: * Capability dev=21 group=00
P2P: * Listen Channel: Regulatory Class 81 Channel 1
nl80211: Scan SSID - hexdump_ascii(len=0): [NULL]
nl80211: Scan extra IEs - hexdump(len=101): xxx
Scan requested (ret=0) - scan timeout 30 seconds
nl80211: Event message available
nl80211: Scan trigger
nl80211: Event message available
nl80211: New scan results available
wlan0: Event SCAN_RESULTS (3) received
nl80211: Received scan results (19 BSSes)
wlan0: BSS: Start scan result update 2

when wlan0 goes to connected or I just turn off the wifi, underruns go
away, I'll check first what rtl8192ce's nl80211 interface implementation
does when asked to perform a scan.

thank you again for your suggestions,
Olivier