Re: [PATCH 1/2] mac80211_hwsim: Set VHT capabilities only for the 5.2 GHz band

[Johannes Berg <johannes@sipsolutions.net>]

On Thu, 2015-04-09 at 10:35 +0300, Jouni Malinen wrote:
> On Wed, Apr 08, 2015 at 06:29:38PM +0000, Peer, Ilan wrote:
> > According to the 802.11ac amendment: "The IEEE 802.11 VHT STA operates in frequency bands below 6 GHz excluding the 2.4 GHz band", so at least the spec. is clear about it. However, I guess it would be possible to enable VHT for 2.4 as well to enjoy some of benefits, but do you see a reason/use case to enable it also for hwsim?
> 
> It does not matter what the standard says on VHT in general; there are
> clearly already products out there that allow some capabilities defined
> in 802.11ac (mainly, 256-QAM) to be used on the 2.4 GHz band.

Sure.

> As far as
> hwsim is concerned, I'm already using it to verify the negotiation part
> for this (see ap_vht_on_24ghz test case).

Oh, I guess I can't apply this patch then. But perhaps we should make
this an optional capability so we can create a new virtual radio
with/without it.

> The main remaining question
> for cfg80211/nl80211 is on whether we can come up with a clean way of
> advertising driver capability for doing this.

I'm not even sure what the question really is. Really you want just high
MCSes, but what should happen OTA? Is interoperability even *desired*,
given that it will never be tested?

johannes