[PATCH v3] mac80211: mesh: set tx_info->hw_queue to the correct queue upon packet forwarding

[PATCH v3] mac80211: mesh: set tx_info->hw_queue to the correct queue upon packet forwarding

[Yaniv Machani]

From: Meirav Kama <meiravk@ti.com>

MP received data frames from another MP. Frames are forwarded
from Rx to Tx to be transmitted to a third MP.
Upon cloning the skb, the tx_info was zeroed, and the
hw_queue wasn't set correctly, causing frames to be
inserted to queue 0 (VOICE). If re-queue occurred for some
reason, frame will be inserted to correct queue 2 (BE).
In this case frames are now dequeued from 2 different queues and
sent out of order.

Signed-off-by: Meirav Kama <meiravk@ti.com>
Signed-off-by: Yaniv Machani <yanivma@ti.com>
---
v3 - update the headline

 net/mac80211/rx.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/net/mac80211/rx.c b/net/mac80211/rx.c
index 9a1eb70..88dc744 100644
--- a/net/mac80211/rx.c
+++ b/net/mac80211/rx.c
@@ -2392,6 +2392,7 @@ ieee80211_rx_h_mesh_fwding(struct ieee80211_rx_data *rx)
 	info->flags |= IEEE80211_TX_INTFL_NEED_TXPROCESSING;
 	info->control.vif = &rx->sdata->vif;
 	info->control.jiffies = jiffies;
+	info->hw_queue = q;
 	if (is_multicast_ether_addr(fwd_hdr->addr1)) {
 		IEEE80211_IFSTA_MESH_CTR_INC(ifmsh, fwded_mcast);
 		memcpy(fwd_hdr->addr2, sdata->vif.addr, ETH_ALEN);
-- 
2.9.0

Re: [PATCH v3] mac80211: mesh: set tx_info->hw_queue to the correct queue upon packet forwarding

[Johannes Berg]

On Mon, 2016-08-08 at 10:06 +0300, Yaniv Machani wrote:
> From: Meirav Kama <meiravk@ti.com>
> 
> MP received data frames from another MP. Frames are forwarded
> from Rx to Tx to be transmitted to a third MP.
> Upon cloning the skb, the tx_info was zeroed, and the
> hw_queue wasn't set correctly, causing frames to be
> inserted to queue 0 (VOICE). If re-queue occurred for some
> reason, frame will be inserted to correct queue 2 (BE).
> In this case frames are now dequeued from 2 different queues and
> sent out of order.

Uh, sorry. I was so focused on the commit message and everything that I
neglected to look into the code change ... :(

>  	info->control.jiffies = jiffies;
> +	info->hw_queue = q;
> 
This is incorrect. 'q' appears to be the AC here, so you need to set
something like vif->hw_queue[q], afaict? Check out tx.c where this is
set.

johannes