From: Govind Singh <govinds@codeaurora.org>
To: ath10k@lists.infradead.org
Cc: linux-wireless@vger.kernel.org, Govind Singh <govinds@codeaurora.org>
Subject: [PATCH v2 00/13] ***Set4: Add support of WCN3990 bus layer support ***
Date: Fri, 23 Mar 2018 10:33:31 +0530 [thread overview]
Message-ID: <1521781424-24972-1-git-send-email-govinds@codeaurora.org> (raw)
This change adds support for integrated wcn3990 chipset on
MSM platforms. WCN3990 is 2x2 802.11ac chipset where wlan
subsystem is interfaced over system interconnect.
Wlan fw runs in Q6 DSP. WCN3990 chipset uses 12 copy engine
for host to target and target to host communication. It has
extra 2 copy engine in rx data path and packet log capability
is exposed via new HTC service over dedicated copy engine.
Each CE has dedicated interrupt of rx path and tx completion.
[CE0] :host->target control and raw streams
[CE1] :target->host HTT
[CE2] :target->host WMI
[CE3] :host->target WMI
[CE4] :host->target HTT
[CE5] :reserved
[CE6] :Target autonomous HIF_memcpy
[CE7] :reserved
[CE8] :reserved
[CE9] :target->host HTT
[CE10] :target->host HTT
[CE11] :target -> host PKTLOG
Changes in V2:
Rebased the set on top of https://patchwork.kernel.org/patch/10298657/.
Removed qcom,<supply>-config and minor clean up in dt binding documentation.
Govind Singh (11):
ath10k: platform driver for WCN3990 SNOC WLAN module
ath10k: add resource init and deinit for WCN3990
ath10k: Add hif start/stop methods for wcn3990 snoc layer
ath10k: Add HTC services for WCN3990
ath10k: Map HTC services to tx/rx pipes for wcn3990
ath10k: Add hif power-up/power-down methods
ath10k: Add hif tx methods for wcn3990
ath10k: Add hif rx methods for wcn3990
ath10k: Modify hif tx paddr to dma_addr_t type
ath10k: Vote for hardware resources for WCN3990
dt: bindings: add bindings for wcn3990 wifi block
Rakesh Pillai (2):
ath10k: Add support to get target info from hif ops
ath10k: Check all CE for data if irq summary is not retained
.../bindings/net/wireless/qcom,ath10k.txt | 31 +
drivers/net/wireless/ath/ath10k/Kconfig | 8 +
drivers/net/wireless/ath/ath10k/Makefile | 3 +
drivers/net/wireless/ath/ath10k/ce.h | 10 +-
drivers/net/wireless/ath/ath10k/core.c | 21 +
drivers/net/wireless/ath/ath10k/hif.h | 15 +-
drivers/net/wireless/ath/ath10k/htc.c | 6 +
drivers/net/wireless/ath/ath10k/htc.h | 4 +
drivers/net/wireless/ath/ath10k/hw.h | 3 +
drivers/net/wireless/ath/ath10k/pci.c | 8 +-
drivers/net/wireless/ath/ath10k/snoc.c | 1411 ++++++++++++++++++++
drivers/net/wireless/ath/ath10k/snoc.h | 95 ++
12 files changed, 1607 insertions(+), 8 deletions(-)
create mode 100644 drivers/net/wireless/ath/ath10k/snoc.c
create mode 100644 drivers/net/wireless/ath/ath10k/snoc.h
--
1.9.1
next reply other threads:[~2018-03-23 5:03 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-03-23 5:03 Govind Singh [this message]
2018-03-23 5:03 ` [PATCH v2 01/13] ath10k: platform driver for WCN3990 SNOC WLAN module Govind Singh
2018-04-19 15:55 ` [v2,01/13] " Kalle Valo
2018-03-23 5:03 ` [PATCH v2 02/13] ath10k: add resource init and deinit for WCN3990 Govind Singh
2018-03-23 5:03 ` [PATCH v2 03/13] ath10k: Add hif start/stop methods for wcn3990 snoc layer Govind Singh
2018-03-23 5:03 ` [PATCH v2 04/13] ath10k: Add HTC services for WCN3990 Govind Singh
2018-03-23 5:03 ` [PATCH v2 05/13] ath10k: Map HTC services to tx/rx pipes for wcn3990 Govind Singh
2018-03-23 5:03 ` [PATCH v2 06/13] ath10k: Add hif power-up/power-down methods Govind Singh
2018-03-23 5:03 ` [PATCH v2 07/13] ath10k: Add hif tx methods for wcn3990 Govind Singh
2018-03-23 5:03 ` [PATCH v2 08/13] ath10k: Add hif rx " Govind Singh
2018-03-23 5:03 ` [PATCH v2 09/13] ath10k: Modify hif tx paddr to dma_addr_t type Govind Singh
2018-03-23 5:03 ` [PATCH v2 10/13] ath10k: Add support to get target info from hif ops Govind Singh
2018-03-23 5:03 ` [PATCH v2 11/13] ath10k: Check all CE for data if irq summary is not retained Govind Singh
2018-03-23 5:03 ` [PATCH v2 12/13] ath10k: Vote for hardware resources for WCN3990 Govind Singh
2018-03-23 5:03 ` [PATCH v2 13/13] dt: bindings: add bindings for wcn3990 wifi block Govind Singh
2018-04-10 14:25 ` [v2,13/13] " Kalle Valo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1521781424-24972-1-git-send-email-govinds@codeaurora.org \
--to=govinds@codeaurora.org \
--cc=ath10k@lists.infradead.org \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).