Re: Strange performance issue when using two devices at once

[Marlon Smith <marlon.smith10@gmail.com>]

On Wed, 2020-01-29 at 11:27 -0800, Ben Greear wrote:
> On 1/29/20 11:22 AM, Marlon Smith wrote:
> > 
> > On Wed, 2020-01-29 at 10:42 -0800, Ben Greear wrote:
> > > 
> > > On 1/29/20 10:39 AM, Marlon Smith wrote:
> > > > 
> > > > 
> > > > Hi everyone,
> > > > 
> > > > I have two RT5370 devices connected to the same access point.
> > > > Both
> > > > devices are very slow, but the instant I disconnect one device,
> > > > the
> > > > other speeds up by a factor of 10.
> > > Out of curiosity, are both of the RT5370 used on the same client
> > > device?
> > > > 
> > > > Did you check that they have unique MAC addresses?
> > > > Thanks,
> > > Ben
> > > > 
> > > > > 
> > > > > 
> > > > The really strange part is that one device will perform slowly
> > > > even
> > > > if
> > > > the other device is basically idle! I've confirmed this with a
> > > > packet
> > > > sniffer.
> > > > 
> > > > I've been trying to do some debugging, and I've found that when
> > > > both
> > > > devices are connected to the access point, they report a large
> > > > number
> > > > of duplicate frames. I added some debug output
> > > > in ieee80211_rx_h_check_dup() to confirm that this only happens
> > > > while
> > > > both devices are connected. The packet sniffer also shows a
> > > > large
> > > > number of retries while this is occurring.
> > > > 
> > > > Using backports 5.3-rc4 for this, but also tested on 4.14-rc2.
> > > > 
> > > > I did post about this previously on this mailing list (RT5370
> > > > performance issues), but I thought I'd post again with this new
> > > > information and more descriptive title. I'm a little bit stuck
> > > > on
> > > > this
> > > > for a while now, so any ideas are much appreciated.
> > > > 
> > > > Thanks!
> > > > 
> > > > Marlon
> > > > 
> > They are on separate devices, although the mac addresses are close.
> > 70:F1:1C:2E:AF:B4 and
> > 70:F1:1C:2E:AF:B6.
> > 
> > However, I have a third device 70:F1:1C:2E:AF:BB which performs
> > well
> > and does not affect the performance of the other two.
> > 
> Have you tried a different AP?
> 
> And also tried using the exact same MAC addresses configured on a
> different
> radio (like ath9k)?
> 
> Thanks,
> Ben
> 
> 

I have tried a different access point in a different environment but no
luck. I'll see if I can configure my laptop to use one of the
problematic devices' mac address.