Re: [RFC PATCH v2 3/3] ath11k: register HE mesh capabilities

[Sven Eckelmann <sven@narfation.org>]

[-- Attachment #1: Type: text/plain, Size: 1041 bytes --]

On Tuesday, 11 June 2019 21:52:20 CEST Sven Eckelmann wrote:
[...]
> 	if (!test_sta_flag(sta, WLAN_STA_RATE_CONTROL))
> 		rate_control_rate_init(sta);
> 
>    /* inform drivers about changes */
> 	rate_control_rate_update(local, sband, sta, changed);
> 
> Both will at least cause a call to ath11k_peer_assoc_prepare + 
> ath11k_wmi_send_peer_assoc_cmd but unfortunately the ath11k firmware hangs 
> afterwards.

The fw hang seems to be related to the not set bss_conf.he_support in 
ath11k_mac_vdev_start_restart. This has to be set when ieee80211_join_mesh 
calls ieee80211_vif_use_channel. Otherwise the firmware will set a HT/VHT mode 
in the firmware. Any sta with an higher phy mode will just hang the firmware.

So the two main problems right now are:

* set bss_conf.he_support during mesh_join before 
  ath11k_mac_vdev_start_restart is called

   - no clue what the best approach is

* let ath11k redo the association procedure with he_cap->has_he set to true 
  when wpa_supplicant is in control of the peers.

Kind regards,
	Sven

[-- Attachment #2: This is a digitally signed message part. --]
[-- Type: application/pgp-signature, Size: 833 bytes --]