From: Elimar Riesebieter <riesebie@lxtec.de>
To: Johannes Berg <johannes@sipsolutions.net>
Cc: linux-wireless@vger.kernel.org
Subject: Re: 2.6.24-rc1 freezes on powerbook at first boot stage
Date: Thu, 15 Nov 2007 19:21:44 +0100 [thread overview]
Message-ID: <20071115182144.GA3199@samweis.home.lxtec.de> (raw)
In-Reply-To: <1195145325.13846.70.camel@johannes.berg>
[-- Attachment #1: Type: text/plain, Size: 6675 bytes --]
On Thu, 15 Nov 2007 the mental interface of
Johannes Berg told:
>
> > > [FWIW, my powerbook worked with -rc1]
> > >
> > > > 2.6.24-rc2 works so lala :)
> > >
> > > > b43 doesn't authenticate via wpa (bluetooth isn't loaded):
> > > > WEXT auth param 4 value 0x0 - ioctl[SIOCSIWAUTH]: Operation not supported
> > > > WEXT auth param 5 value 0x1 - Internet Systems Consortium DHCP Client V3.1.0
> > >
> > > Those error messages are unrelated. My b43 works fine, even with a
> > > multi-MAC patch.
> >
> > I tried it as follows:
> >
> > wpa_supplicant -Dwext -ieth2 -c/etc/wpa_supplicant/wpa_supplicant.conf
> >
> > eth2 is renamed by udev via MAC address.
> >
> > b43-fwcutter intalled
> >
> > Could you please enlighten me.
>
> Well, you haven't said what broke. Those "error" messages above are
> perfectlly normal.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11g ESSID:""
Mode:Managed Channel:0 Access Point: Not-Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Link Quality:0 Signal level:0 Noise level:0
wRx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Nov 15 18:48:04 samweis kernel: b43-phy1 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
Nov 15 18:48:05 samweis kernel: b43-phy1 debug: Chip initialized
Nov 15 18:48:05 samweis kernel: b43-phy1 debug: 30-bit DMA initialized
Nov 15 18:48:05 samweis kernel: input: Unspecified device as /devices/virtual/input/input9
Nov 15 18:48:05 samweis kernel: b43-phy1 debug: Wireless interface started
Nov 15 18:48:05 samweis kernel: b43-phy1 debug: Adding Interface type 2
Nov 15 18:48:05 samweis kernel: ADDRCONF(NETDEV_UP): wlan0: link is not ready
Nov 15 18:48:31 samweis dhclient: Internet Systems Consortium DHCP Client V3.1.0
Nov 15 18:48:33 samweis dhclient: wmaster0: unknown hardware address type 801
# ifconfig wlan0 up
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: Removing Interface type 2
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: Wireless interface stopped
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: DMA-32 0x0200 (RX) max used slots: 1/64
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: DMA-32 0x02A0 (TX) max used slots: 0/128
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: DMA-32 0x0280 (TX) max used slots: 0/128
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: DMA-32 0x0260 (TX) max used slots: 0/128
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: DMA-32 0x0240 (TX) max used slots: 0/128
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: DMA-32 0x0220 (TX) max used slots: 2/128
Nov 15 18:51:01 samweis kernel: b43-phy1 debug: DMA-32 0x0200 (TX) max used slots: 0/128
Nov 15 18:51:29 samweis kernel: b43-phy1 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
Nov 15 18:51:31 samweis kernel: b43-phy1 debug: Chip initialized
Nov 15 18:51:31 samweis kernel: b43-phy1 debug: 30-bit DMA initialized
Nov 15 18:51:31 samweis kernel: Unable to handle kernel paging request for data at address 0x7e13ed24
Nov 15 18:51:31 samweis kernel: Faulting instruction address: 0xc02b3060
Nov 15 18:51:31 samweis kernel: Oops: Kernel access of bad area, sig: 11 [#1]
Nov 15 18:51:31 samweis kernel: PowerMac
Nov 15 18:51:31 samweis kernel: Modules linked in: b43 firmware_class ssb radeon drm hci_usb bluetooth autofs4 ipv6 nfs lockd sunrpc af_packet i2c_dev apm_emu apm_emulation therm_adt746x ams appletouch arc4 usbhid ecb snd_aoa_codec_tas snd_aoa_fabric_layout snd_aoa rc80211_simple snd_aoa_i2sbus snd_pcm_oss snd_mixer_oss firewire_ohci firewire_core crc_itu_t snd_pcm mac80211 cfg80211 snd_timer snd_page_alloc input_polldev ide_cd cdrom snd soundcore snd_aoa_soundbus ehci_hcd ohci_hcd ohci1394 uninorth_agp sungem sungem_phy evdev ieee1394 usbcore agpgart yenta_socket rsrc_nonstatic pcmcia_core unix
Nov 15 18:51:31 samweis kernel: NIP: c02b3060 LR: c02b302c CTR: c02b2ff4
Nov 15 18:51:31 samweis kernel: REGS: c7517ca0 TRAP: 0300 Not tainted (2.6.24-rc2-aragorn)
Nov 15 18:51:31 samweis kernel: MSR: 00009032 <EE,ME,IR,DR> CR: 24084422 XER: 20000000
Nov 15 18:51:31 samweis kernel: DAR: 7e13ed24, DSISR: 40000000
Nov 15 18:51:31 samweis kernel: TASK = c1f81850[3943] 'wpa_supplicant' THREAD: c7516000
Nov 15 18:51:31 samweis kernel: GPR00: bdd880c4 c7517d50 c1f81850 c131f200 f1078164 00000000 00000000 00000010
Nov 15 18:51:31 samweis kernel: GPR08: 00000000 c03b0000 00000000 00000000 24084422 1006dbf8 00000000 00000006
Nov 15 18:51:31 samweis kernel: GPR16: 28244242 100a0000 00000001 100cfb80 c7517e58 ffff8914 c1cd1000 c1c7ad40
Nov 15 18:51:31 samweis kernel: GPR24: c1de5808 c1cf6de0 c1306000 c03b6c60 c0385e24 c0385d70 00000000 c131f200
Nov 15 18:51:31 samweis kernel: NIP [c02b3060] rfkill_register+0x6c/0x12c
Nov 15 18:51:31 samweis kernel: LR [c02b302c] rfkill_register+0x38/0x12c
Nov 15 18:51:31 samweis kernel: Call Trace:
Nov 15 18:51:31 samweis kernel: [c7517d50] [c02b302c] rfkill_register+0x38/0x12c (unreliable)
Nov 15 18:51:31 samweis kernel: [c7517d70] [f26fd594] b43_rfkill_init+0x24/0xb0 [b43]
Nov 15 18:51:31 samweis kernel: [c7517d80] [f26ed324] b43_wireless_core_init+0x614/0x780 [b43]
Nov 15 18:51:31 samweis kernel: [c7517db0] [f26ee254] b43_start+0x94/0xa4 [b43]
Nov 15 18:51:31 samweis kernel: [c7517dd0] [f24b2dac] ieee80211_open+0x1a0/0x3e4 [mac80211]
Nov 15 18:51:31 samweis kernel: [c7517e00] [c024b29c] dev_open+0xb0/0xe8
Nov 15 18:51:31 samweis kernel: [c7517e10] [c024a08c] dev_change_flags+0x90/0x1c0
Nov 15 18:51:31 samweis kernel: [c7517e30] [c02922e0] devinet_ioctl+0x620/0x784
Nov 15 18:51:31 samweis kernel: [c7517ea0] [c02929c8] inet_ioctl+0xcc/0xf8
Nov 15 18:51:31 samweis kernel: [c7517eb0] [c023b22c] sock_ioctl+0x100/0x2b8
Nov 15 18:51:31 samweis kernel: [c7517ed0] [c0097e8c] do_ioctl+0x34/0x98
Nov 15 18:51:31 samweis kernel: [c7517ee0] [c00981c4] vfs_ioctl+0x2d4/0x424
Nov 15 18:51:31 samweis kernel: [c7517f10] [c0098354] sys_ioctl+0x40/0x74
Nov 15 18:51:31 samweis kernel: [c7517f40] [c0011c28] ret_from_syscall+0x0/0x38
Nov 15 18:51:31 samweis kernel: --- Exception: c01 at 0xfcb77fc
Nov 15 18:51:31 samweis kernel: LR = 0xfcb7760
Nov 15 18:51:31 samweis kernel: Instruction dump:
Nov 15 18:51:31 samweis kernel: 4182001c 80010024 7fc3f378 bb61000c 38210020 7c0803a6 4e800020 801f0004
Nov 15 18:51:31 samweis kernel: 3d20c03b 7fe3fb78 3b696c60 5400103a <7c9b002e> 4bfffa25 7c7e1b79 40820074
This is with debugging on.
Elimar
--
You cannot propel yourself forward by
patting yourself on the back.
[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 189 bytes --]
next prev parent reply other threads:[~2007-11-15 18:21 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <20071024120739.GA4897@aragorn.home.lxtec.de>
[not found] ` <20071024124109.GA9442@frodo.home.lxtec.de>
[not found] ` <20071104032006.GG9695@localdomain>
2007-11-13 22:02 ` 2.6.24-rc1 freezes on powerbook at first boot stage Elimar Riesebieter
2007-11-14 15:26 ` Johannes Berg
2007-11-14 19:33 ` Elimar Riesebieter
2007-11-15 16:48 ` Johannes Berg
2007-11-15 18:21 ` Elimar Riesebieter [this message]
2007-11-15 18:26 ` Johannes Berg
2007-11-16 1:29 ` Elimar Riesebieter
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20071115182144.GA3199@samweis.home.lxtec.de \
--to=riesebie@lxtec.de \
--cc=johannes@sipsolutions.net \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox