From: Andrew Morton <akpm@linux-foundation.org>
To: Tim Connors <tconnors@astro.swin.edu.au>
Cc: kernel list <linux-kernel@vger.kernel.org>,
linux-wireless@vger.kernel.org
Subject: Re: iwl4965 dropping packets and __dev_addr_discard: address leakage! da_users=1
Date: Mon, 25 Feb 2008 22:38:23 -0800 [thread overview]
Message-ID: <20080225223823.db13a7fe.akpm@linux-foundation.org> (raw)
In-Reply-To: <slrn-0.9.7.4-5027-27940-200802261551-tc@hexane.ssi.swin.edu.au>
On Tue, 26 Feb 2008 16:22:43 +1100 Tim Connors <tconnors@astro.swin.edu.au> wrote:
> Possibly because of the frequent renegotiating my iwl4965 card has
> been making, it has now decided it's not going to pass packets
> reliably until presumably next time I reboot.
>
> I've noticed messages in syslog that I hadn't seen when things were
> working fine. The problem possibly has only surfaced after rmmodding
> the iwl4965 module, then remodding it. It stays with me through being
> removed and modprobed again. It is being bonded in conjunction with a
> physical ethernet, if that is relevant, although I think I reproduced
> it when it was on its lonesome.
>
>
> Fresh after reboot:
>
> Feb 22 09:49:31 dirac kernel: iwl4965: Intel(R) Wireless WiFi Link 4965AGN driver for Linux, 1.1.17kds
> Feb 22 09:49:31 dirac kernel: iwl4965: Copyright(c) 2003-2007 Intel Corporation
> Feb 22 09:49:31 dirac kernel: ACPI: PCI Interrupt 0000:0c:00.0[A] -> GSI 17 (level, low) -> IRQ 17
> Feb 22 09:49:31 dirac kernel: PCI: Setting latency timer of device 0000:0c:00.0 to 64
> Feb 22 09:49:31 dirac kernel: iwl4965: Detected Intel Wireless WiFi Link 4965AGN
> Feb 22 09:49:31 dirac kernel: ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 21 (level, low) -> IRQ 21
> Feb 22 09:49:31 dirac kernel: PCI: Setting latency timer of device 0000:00:1b.0 to 64
> Feb 22 09:49:31 dirac kernel: iwl4965: Tunable channels: 11 802.11bg, 13 802.11a channels
> Feb 22 09:49:31 dirac kernel: phy0: Selected rate control algorithm 'iwl-4965-rs'
>
> now finished with it, will be deconfigured and rmmodded:
>
> Feb 23 03:05:23 dirac kernel: __dev_addr_discard: address leakage! da_users=1
> Feb 23 03:05:23 dirac kernel: ACPI: PCI interrupt for device 0000:0c:00.0 disabled
>
> The modprobed again:
>
> Feb 23 03:05:35 dirac kernel: iwl4965: Intel(R) Wireless WiFi Link 4965AGN driver for Linux, 1.1.17kds
> Feb 23 03:05:35 dirac kernel: iwl4965: Copyright(c) 2003-2007 Intel Corporation
> Feb 23 03:05:35 dirac kernel: ACPI: PCI Interrupt 0000:0c:00.0[A] -> GSI 17 (level, low) -> IRQ 17
> Feb 23 03:05:35 dirac kernel: PCI: Setting latency timer of device 0000:0c:00.0 to 64
> Feb 23 03:05:35 dirac kernel: iwl4965: Detected Intel Wireless WiFi Link 4965AGN
> Feb 23 03:05:35 dirac kernel: iwl4965: Tunable channels: 11 802.11bg, 13 802.11a channels
> Feb 23 03:05:35 dirac kernel: phy9: Selected rate control algorithm 'iwl-4965-rs'
>
> according to lspci -vvv, 0c:00.0 is:
>
> 0c:00.0 Network controller: Intel Corporation PRO/Wireless 4965 AG or AGN Network Connection (rev 61)
> Subsystem: Intel Corporation Unknown device 1120
> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx+
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
> Latency: 0, Cache Line Size: 64 bytes
> Interrupt: pin A routed to IRQ 379
> Region 0: Memory at f9ffe000 (64-bit, non-prefetchable) [size=8K]
> Capabilities: [c8] Power Management version 3
> Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> Capabilities: [d0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable+
> Address: 00000000fee0300c Data: 4194
> Capabilities: [e0] Express (v1) Endpoint, MSI 00
> DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <512ns, L1 unlimited
> ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset-
> DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported-
> RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+
> MaxPayload 128 bytes, MaxReadReq 128 bytes
> DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq+ AuxPwr+ TransPend-
> LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Latency L0 <128ns, L1 <64us
> ClockPM+ Suprise- LLActRep- BwNot-
> LnkCtl: ASPM L0s Enabled; RCB 64 bytes Disabled- Retrain- CommClk+
> ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
> LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
> Capabilities: [100] Advanced Error Reporting <?>
> Capabilities: [140] Device Serial Number d7-36-9b-ff-ff-e8-13-00
> Kernel driver in use: iwl4965
> Kernel modules: iwl4965
(cc linux-wireless)
What kernel version is this?
Is this a regression from an earlier kenrel version? If so, which?
next parent reply other threads:[~2008-02-26 6:39 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <slrn-0.9.7.4-5027-27940-200802261551-tc@hexane.ssi.swin.edu.au>
2008-02-26 6:38 ` Andrew Morton [this message]
2008-02-26 6:47 ` iwl4965 dropping packets and __dev_addr_discard: address leakage! da_users=1 Tim Connors
2008-02-27 6:14 ` Chatre, Reinette
2008-02-26 8:33 ` Johannes Berg
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20080225223823.db13a7fe.akpm@linux-foundation.org \
--to=akpm@linux-foundation.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-wireless@vger.kernel.org \
--cc=tconnors@astro.swin.edu.au \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox