[PATCH 2/3] rt2x00: Fix partial antenna configuration

[Ivo van Doorn <ivdoorn@gmail.com>]

The if-statement to determine the new TX/RX antenna
configuration was incomplete. It lacks the general
else-clause when the antenna wasn't changed.

This is a correct event, since it can occur when only
one of the antenna's has been changed or when the new
configuration is being forced (like when the interface
has just been added).

Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
---
 drivers/net/wireless/rt2x00/rt2x00config.c |    4 ++++
 1 files changed, 4 insertions(+), 0 deletions(-)

diff --git a/drivers/net/wireless/rt2x00/rt2x00config.c b/drivers/net/wireless/rt2x00/rt2x00config.c
index 3f89516..d134c3b 100644
--- a/drivers/net/wireless/rt2x00/rt2x00config.c
+++ b/drivers/net/wireless/rt2x00/rt2x00config.c
@@ -254,6 +254,8 @@ config:
 			libconf.ant.rx = default_ant->rx;
 		else if (active_ant->rx == ANTENNA_SW_DIVERSITY)
 			libconf.ant.rx = ANTENNA_B;
+		else
+			libconf.ant.rx = active_ant->rx;
 
 		if (conf->antenna_sel_tx)
 			libconf.ant.tx = conf->antenna_sel_tx;
@@ -261,6 +263,8 @@ config:
 			libconf.ant.tx = default_ant->tx;
 		else if (active_ant->tx == ANTENNA_SW_DIVERSITY)
 			libconf.ant.tx = ANTENNA_B;
+		else
+			libconf.ant.tx = active_ant->tx;
 	}
 
 	if (flags & CONFIG_UPDATE_SLOT_TIME) {
-- 
1.5.6.1