* [PATCH 1/4] p54: enable Mesh Point support
@ 2008-11-14 18:41 Christian Lamparter
2008-11-14 22:22 ` Andrey Yurovsky
0 siblings, 1 reply; 3+ messages in thread
From: Christian Lamparter @ 2008-11-14 18:41 UTC (permalink / raw)
To: linux-wireless
Cc: John W Linville, Larry Finger, Johannes Berg, Pavel Roskin,
Andrey Yurovsky
This patch enables Mesh Point operation for any p54 device.
Signed-off-by: Christian Lamparter <chunkeey@web.de>
---
diff -Nurp a/drivers/net/wireless/p54/p54common.c b/drivers/net/wireless/p54/p54common.c
--- a/drivers/net/wireless/p54/p54common.c 2008-11-01 20:41:08.000000000 +0100
+++ b/drivers/net/wireless/p54/p54common.c 2008-11-02 13:34:24.000000000 +0100
@@ -1059,6 +1059,7 @@ static int p54_tx_fill(struct ieee80211_
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
if (info->flags & IEEE80211_TX_CTL_SEND_AFTER_DTIM) {
*aid = 0;
*queue = 3;
@@ -1571,6 +1572,7 @@ static int p54_add_interface(struct ieee
case NL80211_IFTYPE_STATION:
case NL80211_IFTYPE_ADHOC:
case NL80211_IFTYPE_AP:
+ case NL80211_IFTYPE_MESH_POINT:
priv->mode = conf->type;
break;
default:
@@ -1590,6 +1592,7 @@ static int p54_add_interface(struct ieee
p54_setup_mac(dev, P54_FILTER_TYPE_AP, priv->mac_addr);
break;
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
p54_setup_mac(dev, P54_FILTER_TYPE_IBSS, NULL);
break;
default:
@@ -1654,6 +1657,7 @@ static int p54_config_interface(struct i
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
memcpy(priv->bssid, conf->bssid, ETH_ALEN);
ret = p54_set_freq(dev, dev->conf.channel->center_freq);
if (ret)
@@ -1829,6 +1833,7 @@ struct ieee80211_hw *p54_init_common(siz
dev->wiphy->interface_modes = BIT(NL80211_IFTYPE_STATION |
NL80211_IFTYPE_ADHOC |
+ NL80211_IFTYPE_MESH_POINT |
NL80211_IFTYPE_AP);
dev->channel_change_time = 1000; /* TODO: find actual value */
^ permalink raw reply [flat|nested] 3+ messages in thread* Re: [PATCH 1/4] p54: enable Mesh Point support
2008-11-14 18:41 [PATCH 1/4] p54: enable Mesh Point support Christian Lamparter
@ 2008-11-14 22:22 ` Andrey Yurovsky
2008-11-15 16:02 ` [PATCH 1/4] p54: enable Mesh Point support v2 Christian Lamparter
0 siblings, 1 reply; 3+ messages in thread
From: Andrey Yurovsky @ 2008-11-14 22:22 UTC (permalink / raw)
To: Christian Lamparter
Cc: linux-wireless, John W Linville, Larry Finger, Johannes Berg,
Pavel Roskin
Thanks!
Acked-by: Andrey Yurovsky <andrey@cozybit.com>
On Fri, Nov 14, 2008 at 10:41 AM, Christian Lamparter <chunkeey@web.de> wrote:
> This patch enables Mesh Point operation for any p54 device.
>
> Signed-off-by: Christian Lamparter <chunkeey@web.de>
> ---
> diff -Nurp a/drivers/net/wireless/p54/p54common.c b/drivers/net/wireless/p54/p54common.c
> --- a/drivers/net/wireless/p54/p54common.c 2008-11-01 20:41:08.000000000 +0100
> +++ b/drivers/net/wireless/p54/p54common.c 2008-11-02 13:34:24.000000000 +0100
> @@ -1059,6 +1059,7 @@ static int p54_tx_fill(struct ieee80211_
> break;
> case NL80211_IFTYPE_AP:
> case NL80211_IFTYPE_ADHOC:
> + case NL80211_IFTYPE_MESH_POINT:
> if (info->flags & IEEE80211_TX_CTL_SEND_AFTER_DTIM) {
> *aid = 0;
> *queue = 3;
> @@ -1571,6 +1572,7 @@ static int p54_add_interface(struct ieee
> case NL80211_IFTYPE_STATION:
> case NL80211_IFTYPE_ADHOC:
> case NL80211_IFTYPE_AP:
> + case NL80211_IFTYPE_MESH_POINT:
> priv->mode = conf->type;
> break;
> default:
> @@ -1590,6 +1592,7 @@ static int p54_add_interface(struct ieee
> p54_setup_mac(dev, P54_FILTER_TYPE_AP, priv->mac_addr);
> break;
> case NL80211_IFTYPE_ADHOC:
> + case NL80211_IFTYPE_MESH_POINT:
> p54_setup_mac(dev, P54_FILTER_TYPE_IBSS, NULL);
> break;
> default:
> @@ -1654,6 +1657,7 @@ static int p54_config_interface(struct i
> break;
> case NL80211_IFTYPE_AP:
> case NL80211_IFTYPE_ADHOC:
> + case NL80211_IFTYPE_MESH_POINT:
> memcpy(priv->bssid, conf->bssid, ETH_ALEN);
> ret = p54_set_freq(dev, dev->conf.channel->center_freq);
> if (ret)
> @@ -1829,6 +1833,7 @@ struct ieee80211_hw *p54_init_common(siz
>
> dev->wiphy->interface_modes = BIT(NL80211_IFTYPE_STATION |
> NL80211_IFTYPE_ADHOC |
> + NL80211_IFTYPE_MESH_POINT |
> NL80211_IFTYPE_AP);
>
> dev->channel_change_time = 1000; /* TODO: find actual value */
>
^ permalink raw reply [flat|nested] 3+ messages in thread* [PATCH 1/4] p54: enable Mesh Point support v2
2008-11-14 22:22 ` Andrey Yurovsky
@ 2008-11-15 16:02 ` Christian Lamparter
0 siblings, 0 replies; 3+ messages in thread
From: Christian Lamparter @ 2008-11-15 16:02 UTC (permalink / raw)
To: linux-wireless; +Cc: John W Linville
This patch enables Mesh Point operation for any p54 device.
Signed-off-by: Christian Lamparter <chunkeey@web.de>
---
diff -Nurp a/drivers/net/wireless/p54/p54common.c b/drivers/net/wireless/p54/p54common.c
--- a/drivers/net/wireless/p54/p54common.c 2008-11-15 16:50:58.000000000 +0100
+++ b/drivers/net/wireless/p54/p54common.c 2008-11-15 16:50:19.000000000 +0100
@@ -1059,6 +1059,7 @@ static int p54_tx_fill(struct ieee80211_
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
if (info->flags & IEEE80211_TX_CTL_SEND_AFTER_DTIM) {
*aid = 0;
*queue = 3;
@@ -1571,6 +1572,7 @@ static int p54_add_interface(struct ieee
case NL80211_IFTYPE_STATION:
case NL80211_IFTYPE_ADHOC:
case NL80211_IFTYPE_AP:
+ case NL80211_IFTYPE_MESH_POINT:
priv->mode = conf->type;
break;
default:
@@ -1590,6 +1592,7 @@ static int p54_add_interface(struct ieee
p54_setup_mac(dev, P54_FILTER_TYPE_AP, priv->mac_addr);
break;
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
p54_setup_mac(dev, P54_FILTER_TYPE_IBSS, NULL);
break;
default:
@@ -1654,6 +1657,7 @@ static int p54_config_interface(struct i
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
memcpy(priv->bssid, conf->bssid, ETH_ALEN);
ret = p54_set_freq(dev, dev->conf.channel->center_freq);
if (ret)
@@ -1827,9 +1831,10 @@ struct ieee80211_hw *p54_init_common(siz
IEEE80211_HW_SIGNAL_DBM |
IEEE80211_HW_NOISE_DBM;
- dev->wiphy->interface_modes = BIT(NL80211_IFTYPE_STATION |
- NL80211_IFTYPE_ADHOC |
- NL80211_IFTYPE_AP);
+ dev->wiphy->interface_modes = BIT(NL80211_IFTYPE_STATION) |
+ BIT(NL80211_IFTYPE_ADHOC) |
+ BIT(NL80211_IFTYPE_AP) |
+ BIT(NL80211_IFTYPE_MESH_POINT);
dev->channel_change_time = 1000; /* TODO: find actual value */
priv->tx_stats[0].limit = 1; /* Beacon queue */
^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2008-11-15 16:02 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2008-11-14 18:41 [PATCH 1/4] p54: enable Mesh Point support Christian Lamparter
2008-11-14 22:22 ` Andrey Yurovsky
2008-11-15 16:02 ` [PATCH 1/4] p54: enable Mesh Point support v2 Christian Lamparter
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).