From: Bob Copeland <me@bobcopeland.com>
To: nbd@openwrt.org, lrodriguez@atheros.com, mickflemm@gmail.com,
linville@tuxdriver.com, jirislaby@gmail.com
Cc: Bob Copeland <me@bobcopeland.com>,
ath5k-devel@lists.ath5k.org, linux-wireless@vger.kernel.org
Subject: [PATCH 2/3] ath5k: clean up ath5k_hw_set_key
Date: Thu, 27 Nov 2008 09:29:38 -0500 [thread overview]
Message-ID: <20081127142938.5124.70933.sendpatchset@localhost> (raw)
>From 5c4d0c3691a25f158c7e43ce8ca1812cbfd73c82 Mon Sep 17 00:00:00 2001
From: Bob Copeland <me@bobcopeland.com>
Date: Tue, 25 Nov 2008 20:55:21 -0500
Subject: [PATCH] ath5k: clean up ath5k_hw_set_key
With the addition of TKIP (and soon CCMP), key->alg is a more useful
guide to key type than the key length.
This patch cleans up key type assignment in ath5k_hw_set_key by
extracting it into its own function. It also replaces the separate
memcpy() calls for extracting key material into the hardware format
with a loop that works regardless of key size.
Finally, the patch removes support for WEP-128 since it is a
non-standard key length that mac80211 also doesn't use.
Changes-licensed-under: ISC
Signed-off-by: Bob Copeland <me@bobcopeland.com>
---
v2 without the errors, patches 1 and 3 should be ok.
drivers/net/wireless/ath5k/pcu.c | 58 ++++++++++++++++++++++---------------
1 files changed, 34 insertions(+), 24 deletions(-)
diff --git a/drivers/net/wireless/ath5k/pcu.c b/drivers/net/wireless/ath5k/pcu.c
index 79879f2..ad7ea36 100644
--- a/drivers/net/wireless/ath5k/pcu.c
+++ b/drivers/net/wireless/ath5k/pcu.c
@@ -1013,6 +1013,23 @@ int ath5k_hw_is_key_valid(struct ath5k_hw *ah, u16 entry)
AR5K_KEYTABLE_VALID;
}
+static
+int ath5k_keycache_type(const struct ieee80211_key_conf *key)
+{
+ switch (key->alg) {
+ case ALG_TKIP:
+ return AR5K_KEYTABLE_TYPE_TKIP;
+ case ALG_CCMP:
+ return AR5K_KEYTABLE_TYPE_CCM;
+ case ALG_WEP:
+ if (key->keylen == LEN_WEP40)
+ return AR5K_KEYTABLE_TYPE_40;
+ else if (key->keylen == LEN_WEP104)
+ return AR5K_KEYTABLE_TYPE_104;
+ }
+ return -EINVAL;
+}
+
/*
* Set a key entry on the table
*/
@@ -1027,6 +1044,7 @@ int ath5k_hw_set_key(struct ath5k_hw *ah, u16 entry,
u32 keytype;
u16 micentry = entry + AR5K_KEYTABLE_MIC_OFFSET;
bool is_tkip;
+ const u8 *key_ptr;
ATH5K_TRACE(ah->ah_sc);
@@ -1042,33 +1060,25 @@ int ath5k_hw_set_key(struct ath5k_hw *ah, u16 entry,
(is_tkip && micentry > AR5K_KEYTABLE_SIZE))
return -EOPNOTSUPP;
- switch (keylen) {
- /* WEP 40-bit = 40-bit entered key + 24 bit IV = 64-bit */
- case 40 / 8:
- memcpy(&key_v[0], key->key, 5);
- keytype = AR5K_KEYTABLE_TYPE_40;
- break;
+ if (unlikely(keylen > 16))
+ return -EOPNOTSUPP;
- /* WEP 104-bit = 104-bit entered key + 24-bit IV = 128-bit */
- case 104 / 8:
- memcpy(&key_v[0], &key->key[0], 6);
- memcpy(&key_v[2], &key->key[6], 6);
- memcpy(&key_v[4], &key->key[12], 1);
- keytype = AR5K_KEYTABLE_TYPE_104;
- break;
- /* WEP/TKIP 128-bit = 128-bit entered key + 24 bit IV = 152-bit */
- case 128 / 8:
- memcpy(&key_v[0], &key->key[0], 6);
- memcpy(&key_v[2], &key->key[6], 6);
- memcpy(&key_v[4], &key->key[12], 4);
- keytype = is_tkip ?
- AR5K_KEYTABLE_TYPE_TKIP :
- AR5K_KEYTABLE_TYPE_128;
- break;
+ keytype = ath5k_keycache_type(key);
+ if (keytype < 0)
+ return keytype;
- default:
- return -EINVAL; /* shouldn't happen */
+ /*
+ * each key block is 6 bytes wide, written as pairs of
+ * alternating 32 and 16 bit le values.
+ */
+ key_ptr = key->key;
+ for (i = 0; keylen >= 6; keylen -= 6) {
+ memcpy(&key_v[i], key_ptr, 6);
+ i += 2;
+ key_ptr += 6;
}
+ if (keylen)
+ memcpy(&key_v[i], key_ptr, keylen);
/* intentionally corrupt key until mic is installed */
if (is_tkip) {
--
1.5.4.2.182.gb3092
next reply other threads:[~2008-11-27 14:29 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-11-27 14:29 Bob Copeland [this message]
-- strict thread matches above, loose matches on Subject: below --
2008-11-26 21:17 [PATCH 1/3] ath5k: preserve higher order bits when setting mac address Bob Copeland
2008-11-26 21:17 ` [PATCH 2/3] ath5k: clean up ath5k_hw_set_key Bob Copeland
2008-11-27 4:19 ` Bob Copeland
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20081127142938.5124.70933.sendpatchset@localhost \
--to=me@bobcopeland.com \
--cc=ath5k-devel@lists.ath5k.org \
--cc=jirislaby@gmail.com \
--cc=linux-wireless@vger.kernel.org \
--cc=linville@tuxdriver.com \
--cc=lrodriguez@atheros.com \
--cc=mickflemm@gmail.com \
--cc=nbd@openwrt.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).