Re: Still problems to get ath9k in accessmode. Kernel hangs

["W. van den Akker" <listsrv@wilsoft.nl>]

On Saturday 10 January 2009, you wrote:
> W. van den Akker wrote:
> > Did some futher testing to exclude problems....
> > The wlan0 and eth1 are both part of a bridge. I have removed the eth1
> > interface so the the eth1-driver cannot interfer with the ath9k driver.
> > Also no result. The server still locks.
> >
> > What is the right way to combine the eth1 and wlan0 into a bridge. Do I
> > even need  a bridge? The hostapd.config says I must define a bridge when
> > I use the nl80211driver interface.
> > The bridge has an IP adress, wlan0 and eth1 are in the same subnet.
> >
> > When hostapd is started I have some error-messages. Dont know if they can
> > hurt...
> > Failed to set CTS protect in kernel driver
> > Failed to set Short Slot Time option in kernel driver
> > Could not set preamble for kernel driver
>
> I use gentoo's init scripts, but my wlan0 and eth0 are both in a bridge
> (br0) and it works fine.  I don't get the CTS, Short Slot Time, or
> preamble kernel driver errors.  Perhaps you need to comment out a few
> lines in hostapd.conf?
>
> # preamble=1
>
> and I have:
>
> rts_threshold=2347
>
> I'll send you a direct e-mail with my .config and hostapd-wep.conf files
> to help with debugging.

I have used your config files for hostapd. Only change I have made is comment 
out the CONFIG_LIBNL20 because I have no lib for the debian lenny distro. But 
I dont think that will hurt much.
The error messages are gone.

However the system hangup still occurs. It looks like a DMA - ath9k related 
problem.

greetings
WIllem

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.