From: Jouni Malinen <jouni.malinen@atheros.com>
To: "John W. Linville" <linville@tuxdriver.com>
Cc: linux-wireless@vger.kernel.org,
Jouni Malinen <jouni.malinen@atheros.com>
Subject: [PATCH 3/4] ath9k: Fix PS mode operation to receive buffered broadcast/multicast frames
Date: Thu, 14 May 2009 21:28:48 +0300 [thread overview]
Message-ID: <20090514183044.626021480@atheros.com> (raw)
In-Reply-To: 20090514182845.684003914@atheros.com
The previous implementation was moving back to NETWORK SLEEP state
immediately after receiving a Beacon frame. This means that we are
unlikely to receive all the buffered broadcast/multicast frames that
would be sent after DTIM Beacon frames. Fix this by parsing the Beacon
frame and remaining awake, if needed, to receive the buffered
broadcast/multicast frames. The last buffered frame will trigger the
move back into NETWORK SLEEP state.
If the last broadcast/multicast frame is not received properly (or if
the AP fails to send it), the next Beacon frame will work as a backup
trigger for returning into NETWORK SLEEP.
A new debug type, PS (debug=0x800 module parameter), is added to make
it easier to debug potential power save issues in the
future. Currently, this is only used for the Beacon frame and buffered
broadcast/multicast receiving.
Signed-off-by: Jouni Malinen <jouni.malinen@atheros.com>
---
drivers/net/wireless/ath/ath9k/ath9k.h | 1
drivers/net/wireless/ath/ath9k/debug.h | 1
drivers/net/wireless/ath/ath9k/recv.c | 119 +++++++++++++++++++++++++++++++--
3 files changed, 114 insertions(+), 7 deletions(-)
--- wireless-testing.orig/drivers/net/wireless/ath/ath9k/ath9k.h 2009-05-14 21:04:12.000000000 +0300
+++ wireless-testing/drivers/net/wireless/ath/ath9k/ath9k.h 2009-05-14 21:12:24.000000000 +0300
@@ -519,6 +519,7 @@ struct ath_rfkill {
#define SC_OP_LED_ON BIT(13)
#define SC_OP_SCANNING BIT(14)
#define SC_OP_TSF_RESET BIT(15)
+#define SC_OP_WAIT_FOR_CAB BIT(16)
struct ath_bus_ops {
void (*read_cachesize)(struct ath_softc *sc, int *csz);
--- wireless-testing.orig/drivers/net/wireless/ath/ath9k/recv.c 2009-05-14 21:12:22.000000000 +0300
+++ wireless-testing/drivers/net/wireless/ath/ath9k/recv.c 2009-05-14 21:12:24.000000000 +0300
@@ -473,6 +473,112 @@ void ath_flushrecv(struct ath_softc *sc)
spin_unlock_bh(&sc->rx.rxflushlock);
}
+static bool ath_beacon_dtim_pending_cab(struct sk_buff *skb)
+{
+ /* Check whether the Beacon frame has DTIM indicating buffered bc/mc */
+ struct ieee80211_mgmt *mgmt;
+ u8 *pos, *end, id, elen;
+ struct ieee80211_tim_ie *tim;
+
+ mgmt = (struct ieee80211_mgmt *)skb->data;
+ pos = mgmt->u.beacon.variable;
+ end = skb->data + skb->len;
+
+ while (pos + 2 < end) {
+ id = *pos++;
+ elen = *pos++;
+ if (pos + elen > end)
+ break;
+
+ if (id == WLAN_EID_TIM) {
+ if (elen < sizeof(*tim))
+ break;
+ tim = (struct ieee80211_tim_ie *) pos;
+ if (tim->dtim_count != 0)
+ break;
+ return tim->bitmap_ctrl & 0x01;
+ }
+
+ pos += elen;
+ }
+
+ return false;
+}
+
+static void ath_rx_ps_back_to_sleep(struct ath_softc *sc)
+{
+ sc->sc_flags &= ~(SC_OP_WAIT_FOR_BEACON | SC_OP_WAIT_FOR_CAB);
+ if (sc->hw->conf.flags & IEEE80211_CONF_PS)
+ ath9k_hw_setpower(sc->sc_ah, ATH9K_PM_NETWORK_SLEEP);
+}
+
+static void ath_rx_ps_beacon(struct ath_softc *sc, struct sk_buff *skb)
+{
+ struct ieee80211_mgmt *mgmt;
+
+ if (skb->len < 24 + 8 + 2 + 2)
+ return;
+
+ mgmt = (struct ieee80211_mgmt *)skb->data;
+ if (memcmp(sc->curbssid, mgmt->bssid, ETH_ALEN) != 0)
+ return; /* not from our current AP */
+
+ if (!(sc->hw->conf.flags & IEEE80211_CONF_PS)) {
+ /* We are not in PS mode anymore; remain awake */
+ DPRINTF(sc, ATH_DBG_PS, "Not in PS mode anymore, remain "
+ "awake\n");
+ sc->sc_flags &= ~(SC_OP_WAIT_FOR_BEACON | SC_OP_WAIT_FOR_CAB);
+ return;
+ }
+
+ if (ath_beacon_dtim_pending_cab(skb)) {
+ /*
+ * Remain awake waiting for buffered broadcast/multicast
+ * frames.
+ */
+ DPRINTF(sc, ATH_DBG_PS, "Received DTIM beacon indicating "
+ "buffered broadcast/multicast frame(s)\n");
+ sc->sc_flags |= SC_OP_WAIT_FOR_CAB;
+ return;
+ }
+
+ if (sc->sc_flags & SC_OP_WAIT_FOR_CAB) {
+ /*
+ * This can happen if a broadcast frame is dropped or the AP
+ * fails to send a frame indicating that all CAB frames have
+ * been delivered.
+ */
+ DPRINTF(sc, ATH_DBG_PS, "PS wait for CAB frames timed out\n");
+ }
+
+ /* No more broadcast/multicast frames to be received at this point. */
+ ath_rx_ps_back_to_sleep(sc);
+}
+
+static void ath_rx_ps(struct ath_softc *sc, struct sk_buff *skb)
+{
+ struct ieee80211_hdr *hdr;
+
+ hdr = (struct ieee80211_hdr *)skb->data;
+
+ /* Process Beacon and CAB receive in PS state */
+ if (ieee80211_is_beacon(hdr->frame_control))
+ ath_rx_ps_beacon(sc, skb);
+ else if ((sc->sc_flags & SC_OP_WAIT_FOR_CAB) &&
+ (ieee80211_is_data(hdr->frame_control) ||
+ ieee80211_is_action(hdr->frame_control)) &&
+ is_multicast_ether_addr(hdr->addr1) &&
+ !ieee80211_has_moredata(hdr->frame_control)) {
+ DPRINTF(sc, ATH_DBG_PS, "All PS CAB frames received, back to "
+ "sleep\n");
+ /*
+ * No more broadcast/multicast frames to be received at this
+ * point.
+ */
+ ath_rx_ps_back_to_sleep(sc);
+ }
+}
+
static void ath_rx_send_to_mac80211(struct ath_softc *sc, struct sk_buff *skb,
struct ieee80211_rx_status *rx_status)
{
@@ -667,8 +773,6 @@ int ath_rx_tasklet(struct ath_softc *sc,
rx_status.flag &= ~RX_FLAG_DECRYPTED;
}
- ath_rx_send_to_mac80211(sc, skb, &rx_status);
-
/* We will now give hardware our shiny new allocated skb */
bf->bf_mpdu = requeue_skb;
bf->bf_buf_addr = dma_map_single(sc->dev, requeue_skb->data,
@@ -680,6 +784,7 @@ int ath_rx_tasklet(struct ath_softc *sc,
bf->bf_mpdu = NULL;
DPRINTF(sc, ATH_DBG_FATAL,
"dma_mapping_error() on RX\n");
+ ath_rx_send_to_mac80211(sc, skb, &rx_status);
break;
}
bf->bf_dmacontext = bf->bf_buf_addr;
@@ -695,11 +800,11 @@ int ath_rx_tasklet(struct ath_softc *sc,
sc->rx.rxotherant = 0;
}
- if (ieee80211_is_beacon(fc) &&
- (sc->sc_flags & SC_OP_WAIT_FOR_BEACON)) {
- sc->sc_flags &= ~SC_OP_WAIT_FOR_BEACON;
- ath9k_hw_setpower(sc->sc_ah, ATH9K_PM_NETWORK_SLEEP);
- }
+ if (unlikely(sc->sc_flags & SC_OP_WAIT_FOR_BEACON))
+ ath_rx_ps(sc, skb);
+
+ ath_rx_send_to_mac80211(sc, skb, &rx_status);
+
requeue:
list_move_tail(&bf->list, &sc->rx.rxbuf);
ath_rx_buf_link(sc, bf);
--- wireless-testing.orig/drivers/net/wireless/ath/ath9k/debug.h 2009-05-14 21:04:11.000000000 +0300
+++ wireless-testing/drivers/net/wireless/ath/ath9k/debug.h 2009-05-14 21:12:24.000000000 +0300
@@ -29,6 +29,7 @@ enum ATH_DEBUG {
ATH_DBG_BEACON = 0x00000100,
ATH_DBG_CONFIG = 0x00000200,
ATH_DBG_FATAL = 0x00000400,
+ ATH_DBG_PS = 0x00000800,
ATH_DBG_ANY = 0xffffffff
};
--
--
Jouni Malinen PGP id EFC895FA
next prev parent reply other threads:[~2009-05-14 18:30 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-05-14 18:28 [PATCH 0/4] ath9k: Power save mode fixes Jouni Malinen
2009-05-14 18:28 ` [PATCH 1/4] ath9k: Fix a check for multicast address for virtual wiphy Jouni Malinen
2009-05-14 18:28 ` [PATCH 2/4] ath9k: Clean up RX processing a bit Jouni Malinen
2009-05-14 18:28 ` Jouni Malinen [this message]
2009-05-14 18:28 ` [PATCH 4/4] ath9k: Move PS wakeup/restore calls from isr to tasklet Jouni Malinen
2009-05-15 6:47 ` Luis R. Rodriguez
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090514183044.626021480@atheros.com \
--to=jouni.malinen@atheros.com \
--cc=linux-wireless@vger.kernel.org \
--cc=linville@tuxdriver.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).