From: Kalle Valo <kalle.valo@iki.fi>
To: "John W. Linville" <linville@tuxdriver.com>
Cc: linux-wireless@vger.kernel.org
Subject: [PATCH 04/33] wl12xx: reserve buffer for partition command in struct wl12xx
Date: Fri, 12 Jun 2009 14:14:41 +0300 [thread overview]
Message-ID: <20090612111441.8877.77502.stgit@tikku> (raw)
In-Reply-To: <20090612110225.8877.92418.stgit@tikku>
From: Kalle Valo <kalle.valo@nokia.com>
This is now DMA safe.
Signed-off-by: Kalle Valo <kalle.valo@nokia.com>
---
drivers/net/wireless/wl12xx/spi.c | 22 ++++++++++++++--------
drivers/net/wireless/wl12xx/spi.h | 6 +++---
2 files changed, 17 insertions(+), 11 deletions(-)
diff --git a/drivers/net/wireless/wl12xx/spi.c b/drivers/net/wireless/wl12xx/spi.c
index abdf171..fb7c52c 100644
--- a/drivers/net/wireless/wl12xx/spi.c
+++ b/drivers/net/wireless/wl12xx/spi.c
@@ -167,24 +167,26 @@ void wl12xx_spi_init(struct wl12xx *wl)
* | |
*
*/
-void wl12xx_set_partition(struct wl12xx *wl,
+int wl12xx_set_partition(struct wl12xx *wl,
u32 mem_start, u32 mem_size,
u32 reg_start, u32 reg_size)
{
- u8 tx_buf[sizeof(u32) + 2 * sizeof(struct wl12xx_partition)];
struct wl12xx_partition *partition;
struct spi_transfer t;
struct spi_message m;
+ size_t len, cmd_len;
u32 *cmd;
- size_t len;
int addr;
+ cmd_len = sizeof(u32) + 2 * sizeof(struct wl12xx_partition);
+ cmd = kzalloc(cmd_len, GFP_KERNEL);
+ if (!cmd)
+ return -ENOMEM;
+
spi_message_init(&m);
memset(&t, 0, sizeof(t));
- memset(tx_buf, 0, sizeof(tx_buf));
- cmd = (u32 *) tx_buf;
- partition = (struct wl12xx_partition *) (tx_buf + sizeof(u32));
+ partition = (struct wl12xx_partition *) (cmd + 1);
addr = HW_ACCESS_PART0_SIZE_ADDR;
len = 2 * sizeof(struct wl12xx_partition);
@@ -244,11 +246,15 @@ void wl12xx_set_partition(struct wl12xx *wl,
wl->virtual_mem_addr = 0;
wl->virtual_reg_addr = mem_size;
- t.tx_buf = tx_buf;
- t.len = sizeof(tx_buf);
+ t.tx_buf = cmd;
+ t.len = cmd_len;
spi_message_add_tail(&t, &m);
spi_sync(wl->spi, &m);
+
+ kfree(cmd);
+
+ return 0;
}
void wl12xx_spi_read(struct wl12xx *wl, int addr, void *buf,
diff --git a/drivers/net/wireless/wl12xx/spi.h b/drivers/net/wireless/wl12xx/spi.h
index f3f1895..7edb218 100644
--- a/drivers/net/wireless/wl12xx/spi.h
+++ b/drivers/net/wireless/wl12xx/spi.h
@@ -88,9 +88,9 @@ void wl12xx_reg_write32(struct wl12xx *wl, int addr, u32 val);
/* INIT and RESET words */
void wl12xx_spi_reset(struct wl12xx *wl);
void wl12xx_spi_init(struct wl12xx *wl);
-void wl12xx_set_partition(struct wl12xx *wl,
- u32 part_start, u32 part_size,
- u32 reg_start, u32 reg_size);
+int wl12xx_set_partition(struct wl12xx *wl,
+ u32 part_start, u32 part_size,
+ u32 reg_start, u32 reg_size);
static inline u32 wl12xx_read32(struct wl12xx *wl, int addr)
{
next prev parent reply other threads:[~2009-06-12 11:15 UTC|newest]
Thread overview: 34+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-06-12 11:14 [PATCH 00/33] wl12xx update for 2.6.32 Kalle Valo
2009-06-12 11:14 ` [PATCH 01/33] wl12xx: cmd and acx interface rework Kalle Valo
2009-06-12 11:14 ` [PATCH 02/33] wl12xx: reserver buffer for read32()/write32() in struct wl12xx Kalle Valo
2009-06-12 11:14 ` [PATCH 03/33] wl12xx: fix error handling in wl12xx_probe() Kalle Valo
2009-06-12 11:14 ` Kalle Valo [this message]
2009-06-12 11:14 ` [PATCH 05/33] wl12xx: allocate buffer spi read/write command buffer kzalloc() Kalle Valo
2009-06-12 11:14 ` [PATCH 06/33] wl12xx: allocate buffer the spi busy word from struct wl12xx Kalle Valo
2009-06-12 11:15 ` [PATCH 07/33] wl12xx: use wl12xx_mem_read32() to read the rx counter Kalle Valo
2009-06-12 11:15 ` [PATCH 08/33] wl12xx: fix rx descriptor use Kalle Valo
2009-06-12 11:15 ` [PATCH 09/33] wl12xx: removed chipset interrupt source configuration from fw wakeup Kalle Valo
2009-06-12 11:15 ` [PATCH 10/33] wl12xx: add wl12xx_spi_reg_read() and wl12xx_spi_reg_write() functions Kalle Valo
2009-06-12 11:15 ` [PATCH 11/33] wl12xx: moved firmware version reading routine to chip-specific functions Kalle Valo
2009-06-12 11:15 ` [PATCH 12/33] wl12xx: add support for new WL1271 chip revision Kalle Valo
2009-06-12 11:15 ` [PATCH 13/33] wl12xx: add support for fixed address in wl12xx_spi_read Kalle Valo
2009-06-12 11:15 ` [PATCH 14/33] wl12xx: pass the wake up condition when configuring the wake up event Kalle Valo
2009-06-12 11:15 ` [PATCH 15/33] wl12xx: Moved wl1251 TX path implementation into chip specific files Kalle Valo
2009-06-12 11:16 ` [PATCH 16/33] wl12xx: Add support for block reading from a fixed register address Kalle Valo
2009-06-12 11:16 ` [PATCH 17/33] wl12xx: Fix incorrect warning message Kalle Valo
2009-06-12 11:16 ` [PATCH 18/33] wl12xx: Fix CMD_TEST regression via netlink Kalle Valo
2009-06-12 11:16 ` [PATCH 19/33] wl12xx: protect wl12xx_op_set_rts_threshold() Kalle Valo
2009-06-12 11:16 ` [PATCH 20/33] wl12xx: optimise elp wakeup and sleep calls Kalle Valo
2009-06-12 11:16 ` [PATCH 21/33] wl12xx: check if elp wakeup failed Kalle Valo
2009-06-12 11:16 ` [PATCH 22/33] wl12xx: enable ELP mode Kalle Valo
2009-06-12 11:16 ` [PATCH 23/33] wl12xx: Assign value to rx msdu lifetime variable Kalle Valo
2009-06-12 11:16 ` [PATCH 24/33] wl12xx: Use chipset specific join commands Kalle Valo
2009-06-12 11:16 ` [PATCH 25/33] wl12xx: rename wl1251.c wl1251_ops.c Kalle Valo
2009-06-12 11:17 ` [PATCH 26/33] wl12xx: rename driver to wl1251 Kalle Valo
2009-06-12 11:17 ` [PATCH 27/33] wl1251: remove wl1271_setup() Kalle Valo
2009-06-12 11:17 ` [PATCH 28/33] wl1251: add wl1251 prefix to all 1251 files Kalle Valo
2009-06-12 11:17 ` [PATCH 29/33] wl1251: rename wl12xx.h to wl1251.h Kalle Valo
2009-06-12 11:17 ` [PATCH 30/33] wl12xx: remove unused wl12xx_hw_init_mem_config() Kalle Valo
2009-06-12 11:17 ` [PATCH 31/33] wl1251: use wl1251 prefix everywhere Kalle Valo
2009-06-12 11:17 ` [PATCH 32/33] wl1251: fix a checkpatch warning Kalle Valo
2009-06-12 11:17 ` [PATCH 33/33] wl1251: change psm enabled/disabled info to debug Kalle Valo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090612111441.8877.77502.stgit@tikku \
--to=kalle.valo@iki.fi \
--cc=linux-wireless@vger.kernel.org \
--cc=linville@tuxdriver.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).