Re: [rt2x00-users] [PATCH] rt2x00: Fix TX status reporting

[Ivo van Doorn <ivdoorn@gmail.com>]

On Saturday 29 August 2009, Benoit PAPILLAULT wrote:
> Ivo van Doorn a écrit :
> > Not all values of the TX status enumeration were covered during
> > updating of the TX statistics. This could lead to wrong bitrate
> > tuning but also wrong behavior in tools like hostapd.
> >
> > Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
> I have a pending patch about TX status that changed the meaning of
> TXDONE_FALLBACK just a bit... just to avoid this change in fact.
> I should be able to send those patches in few hours.
> 
> In my code, you success/failure of the packet is reported with
> TXDONE_SUCCESS / TXDONE_FAILURE. The TXDONE_FALLBACK is set
> independently to indicate that a fallback rate table has been used
> (and this could be the case for either success or failure).

Well that shouldn't block this patch at this time since it is a bugfix which
is quite important to get minstrel and hostapd working properly.

Once I have reviewed your patch it can be send upstream immediately or
in a single batch together with the rt2800pci driver. ;)

Ivo