Re: [PATCH 1/2] ath5k: fix error handling in ath5k_hw_dma_stop

[Stanislaw Gruszka <sgruszka@redhat.com>]

On Mon, Jan 24, 2011 at 11:31:43PM -0500, Bob Copeland wrote:
> Review spotted a problem with the error handling in ath5k_hw_dma_stop:
> a successful return from ath5k_hw_stop_tx_dma will be treated as
> an error, so we always bail out of the loop after processing a single
> active queue.  As a result, we may not actually stop some queues during
> reset.
> 
> Signed-off-by: Bob Copeland <me@bobcopeland.com>
> ---
> These two patches fix some buglets I found when reviewing some old code.
> 
>  drivers/net/wireless/ath/ath5k/dma.c |    2 +-
>  1 files changed, 1 insertions(+), 1 deletions(-)
> 
> diff --git a/drivers/net/wireless/ath/ath5k/dma.c b/drivers/net/wireless/ath/ath5k/dma.c
> index 0064be7..e828b98 100644
> --- a/drivers/net/wireless/ath/ath5k/dma.c
> +++ b/drivers/net/wireless/ath/ath5k/dma.c
> @@ -838,7 +838,7 @@ int ath5k_hw_dma_stop(struct ath5k_hw *ah)
>  	for (i = 0; i < qmax; i++) {
>  		err = ath5k_hw_stop_tx_dma(ah, i);
>  		/* -EINVAL -> queue inactive */
> -		if (err != -EINVAL)
> +		if (err && err != -EINVAL)
>  			return err;
>  	}

Patch is good, but does not make code fully correct. When last queue
is inactive, we return -EINVAL from ath5_hw_dma_stop(). So we need
also:

 		if (err && err != -EINVAL)
 			return err;
+		err = 0;
 	}

But perhaps, would be better just return 0 from 
ath5k_hw_stop_tx_dma() when queue is inactive.

I think that could fix "ath5k phy0: can't reset hardware (-5)"
bugs reported in a few places, so patch should go to stable
as well.

Stanislaw