Re: [PATCH 2/4] ath9k: fix stopping tx dma on reset

[Vasanthakumar Thiagarajan <vasanth@atheros.com>]

On Thu, Mar 10, 2011 at 06:05:01AM +0530, Felix Fietkau wrote:
> +bool ath9k_hw_abort_tx_dma(struct ath_hw *ah)
> +{
> +	int i, q;
> +
> +	REG_WRITE(ah, AR_Q_TXD, AR_Q_TXD_M);
> +
> +	REG_SET_BIT(ah, AR_PCU_MISC, AR_PCU_FORCE_QUIET_COLL | AR_PCU_CLEAR_VMF);
> +	REG_SET_BIT(ah, AR_DIAG_SW, AR_DIAG_FORCE_CH_IDLE_HIGH);
> +	REG_SET_BIT(ah, AR_D_GBL_IFS_MISC, AR_D_GBL_IFS_MISC_IGNORE_BACKOFF);
> +
> +	for (q = 0; q < AR_NUM_QCU; q++) {
> +		for (i = 1000; i > 0; i--) {
> +			if (!ath9k_hw_numtxpending(ah, q))
> +				break;
> +
> +			udelay(5);
> +		}
> +	}
> +	if (!i)
> +		return false;

Here the assumption looks like a reset would follow to configure
those registers back, may be some comment will be useful.

> diff --git a/drivers/net/wireless/ath/ath9k/xmit.c b/drivers/net/wireless/ath/ath9k/xmit.c
> index e16136d..bb1d29e 100644
> --- a/drivers/net/wireless/ath/ath9k/xmit.c
> +++ b/drivers/net/wireless/ath/ath9k/xmit.c
> @@ -1194,16 +1194,14 @@ bool ath_drain_all_txq(struct ath_softc *sc, bool retry_tx)
>  	if (sc->sc_flags & SC_OP_INVALID)
>  		return true;
>  
> -	/* Stop beacon queue */
> -	ath9k_hw_stoptxdma(sc->sc_ah, sc->beacon.beaconq);
> +	ath9k_hw_abort_tx_dma(ah);
>  
> -	/* Stop data queues */
> +	/* Check if any queue remains active */
>  	for (i = 0; i < ATH9K_NUM_TX_QUEUES; i++) {
> -		if (ATH_TXQ_SETUP(sc, i)) {
> -			txq = &sc->tx.txq[i];
> -			ath9k_hw_stoptxdma(ah, txq->axq_qnum);
> -			npend += ath9k_hw_numtxpending(ah, txq->axq_qnum);
> -		}
> +		if (!ATH_TXQ_SETUP(sc, i))
> +			continue;
> +
> +		npend += ath9k_hw_numtxpending(ah, sc->tx.txq[i].axq_qnum);

This can be moved to ath9k_hw_abort_tx_dma() and make it return
npend as the current return value is unused anyway.

Vasanth