[RFC 04/12] mac80211: add support for control port protocol in AP mode

[Johannes Berg <johannes@sipsolutions.net>]

From: Johannes Berg <johannes.berg@intel.com>

This will allow us to support dynamic WEP with 802.1X
properly in mac80211 by not encrypting outgoing and
accepting unencrypted incoming frames.

Signed-off-by: Johannes Berg <johannes.berg@intel.com>
---
 net/mac80211/cfg.c   |   21 ++++++++++++++++++++-
 net/mac80211/iface.c |   13 ++++++++++++-
 2 files changed, 32 insertions(+), 2 deletions(-)

--- a/net/mac80211/cfg.c	2011-10-13 13:16:27.000000000 +0200
+++ b/net/mac80211/cfg.c	2011-10-13 21:53:56.000000000 +0200
@@ -576,6 +576,8 @@ static int ieee80211_add_beacon(struct w
 {
 	struct ieee80211_sub_if_data *sdata;
 	struct beacon_data *old;
+	struct ieee80211_sub_if_data *vlan;
+	int ret;
 
 	sdata = IEEE80211_DEV_TO_SUB_IF(dev);
 
@@ -583,7 +585,24 @@ static int ieee80211_add_beacon(struct w
 	if (old)
 		return -EALREADY;
 
-	return ieee80211_config_beacon(sdata, params);
+	ret = ieee80211_config_beacon(sdata, params);
+	if (ret)
+		return ret;
+
+	/*
+	 * Apply control port protocol, this allows us to
+	 * not encrypt dynamic WEP control frames.
+	 */
+	sdata->control_port_protocol = params->crypto.control_port_ethertype;
+	sdata->control_port_no_encrypt = params->crypto.control_port_no_encrypt;
+	list_for_each_entry(vlan, &sdata->u.ap.vlans, u.vlan.list) {
+		vlan->control_port_protocol =
+			params->crypto.control_port_ethertype;
+		vlan->control_port_no_encrypt =
+			params->crypto.control_port_no_encrypt;
+	}
+
+	return 0;
 }
 
 static int ieee80211_set_beacon(struct wiphy *wiphy, struct net_device *dev,
--- a/net/mac80211/iface.c	2011-10-13 13:16:27.000000000 +0200
+++ b/net/mac80211/iface.c	2011-10-13 13:45:15.000000000 +0200
@@ -188,11 +188,22 @@ static int ieee80211_do_open(struct net_
 		if (!is_valid_ether_addr(sdata->u.wds.remote_addr))
 			return -ENOLINK;
 		break;
-	case NL80211_IFTYPE_AP_VLAN:
+	case NL80211_IFTYPE_AP_VLAN: {
+		struct ieee80211_sub_if_data *master;
+
 		if (!sdata->bss)
 			return -ENOLINK;
+
 		list_add(&sdata->u.vlan.list, &sdata->bss->vlans);
+
+		master = container_of(sdata->bss,
+				      struct ieee80211_sub_if_data, u.ap);
+		sdata->control_port_protocol =
+			master->control_port_protocol;
+		sdata->control_port_no_encrypt =
+			master->control_port_no_encrypt;
 		break;
+		}
 	case NL80211_IFTYPE_AP:
 		sdata->bss = &sdata->u.ap;
 		break;