[PATCH v3 3/3] brcmfmac: Handle status == BRCMF_E_STATUS_ABORT in cfg80211_escan_handler

[Hans de Goede <hdegoede@redhat.com>]

If a scan gets aborted BRCMF_SCAN_STATUS_BUSY gets cleared in
cfg->scan_status and when we receive an abort event from the firmware
the BRCMF_SCAN_STATUS_BUSY check in the cfg80211_escan_handler will
trigger resulting in multiple errors getting logged.

Check for a status of BRCMF_E_STATUS_ABORT and in this case simply
cleanly exit the cfg80211_escan_handler. This also avoids a
BRCMF_E_STATUS_ABORT event arriving after a new scan has been started
causing the new scan to complete prematurely without any data.

Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Acked-by: Arend van Spriel <arend.vanspriel@broadcom.com>
---
Changes in v3:
-Add Arend's Acked-by
---
 drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
index 7765ad0..4e1ca69 100644
--- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
@@ -3097,6 +3097,9 @@ brcmf_cfg80211_escan_handler(struct brcmf_if *ifp,
 
 	status = e->status;
 
+	if (status == BRCMF_E_STATUS_ABORT)
+		goto exit;
+
 	if (!test_bit(BRCMF_SCAN_STATUS_BUSY, &cfg->scan_status)) {
 		brcmf_err("scan not ready, bsscfgidx=%d\n", ifp->bsscfgidx);
 		return -EPERM;
-- 
2.9.3